I have it fixed with this tube: https://www.aquatuning.no/vannkjoeling/slanger/tubes/2265/masterkleer-tubing-pvc-17-4/13mm-1/2-id-clear
Best regards, Plamen On Saturday, April 24, 2021, Kurt Nowak via cctalk <[email protected]> wrote: > I was going to mention him too but you beat me to it. He does really great > nice work. I've had a few QIC drive rollers replaced through him. > > http://www.terrysrubberrollers.com/ > > -Kurt > > On Fri, Apr 23, 2021, 20:32 Chuck Guzis via cctalk <[email protected]> > wrote: > > > On 4/23/21 8:11 PM, Curious Marc via cctalk wrote: > > > I tired several methods which worked to some extent (afore mentioned > > silicone tubes, shrink wrap, eBay bought molded rubber overwraps, > machined > > grooves and add O-rings), but now I just strip my capstans clean and coat > > them with plasti-dip. Methods in shown my various videos (like here > > https://youtu.be/cTZCD4OXETk ). Only plastidip and o-rings have been > > durable enough in the long run, and plasti-dip is easier. I have not > done a > > capstan this large though. There are also some folks out there that will > > also commercially recoat a capstan with correctly molded and vulcanized > > rubber. > > > Marc > > > > In the past, I've used this guy: > > > > http://www.terrysrubberrollers.com/ > > > > Top-notch work. > > > > --Chuck > > > > >
