Not aware of any, however if there is a C compiler for the Pro 300 series then you could potentially adapt my user mode router to the Pro 300. In fact, it might be a fun project. However, it isn't the full DECnet stack, just the router and a little bit of the Network Management layer. I am trying to repair my real Pro 350, although I am not having much luck so far.
Regards Rob > -----Original Message----- > From: cctalk <[email protected]> On Behalf Of Bob Smith via > cctalk > Sent: 17 May 2021 19:43 > To: General Discussion: On-Topic and Off-Topic Posts > <[email protected]> > Subject: DECNet for Pro 300 series boxes > > My recollection of Decnet for Pro boxes is that the available SW was for an > end node and not a routing or other capability for the > 380/350/325 boxes. > While that memory might be incorrect, are there any DecNet packages for > the Pro family available anywhere? > a few hours of searching did not turn up any thing but PDFs about the > software. > thanks in advance for any replies. > bob
