Bill Thanks for the offer of the DosTek 440a. However, my problem is getting the 232 output to wiggle a CRO not to input and log the serial data.
Fanuc manuals 1788.pdf, on VintageComputer.net, looks as though it contains more detail than the PPR and System P manuals and may reward study. Martin -----Original Message----- From: cctalk [mailto:[email protected]] On Behalf Of Bill Degnan via cctalk Sent: 10 April 2022 00:14 To: Eric Moore <[email protected]>; General Discussion: On-Topic and Off-Topic Posts <[email protected]> Subject: Re: Fanuc PPR - Paper Tape Punch, Printer and Reader : Not quite working I have a dostek 440a for sale and notes about my fanuc tape unit here. https://www.vintagecomputer.net/fanuc/index.cfm On Sat, Apr 9, 2022, 6:51 PM Eric Moore via cctalk <[email protected]> wrote: > Hi Martin, I use the PPR for all kinds of paper tape shennanigans. > > https://youtu.be/hGr0F9a7x1A > > Remove all but the first jumper, and that may help with your issues. I > found at one point the jumper settings, but will need to search. > > -Eric > > > > On Sat, Apr 9, 2022, 4:56 PM Martin Bishop via cctalk < > [email protected]> > wrote: > > > A nicely made yellow box with a rather poor manual - both lost in > > translation and limited in scope. > > > > Working on setting one to work, but can't get anything out of the > > serial port. In drives the punch, and the punched data verifies > > (based on a > QL). > > In also drives the printer, although somewhat garbled, perhaps due > > to BCD coding or perhaps due to invalid parity (which is configured > > as no > check). > > The reader 'reads' tape both in response to X/ON over RS232 and in > response > > to front panel keys. However, nothing is emitted onto 232. The D25 > > - > D-9 > > transition has all the RTS/CTS and DSR/DTR/DCD lines knitted > appropriately > > and indicating 'correctly' on blinkenlites. Interestingly, on long > > test tapes the reader does not fall off the end but stops, > > repeatably after > ~49" > > which is remarkably close to 512 octets. Finally, the CNC > > termination octets : % (ASCII) and 0x80 (BCD : RS-244) don't seem to > > impress the > reader > > - nothing changes. > > > > Specific queries: > > - Are there any magic control codes or handshaking rituals to coax > > data out of the reader > > - Is the PPR to CNC Controller interface protocol manual available > > as pdf > > - Where can I find drawings for the PPR's electronics, most > > importantly the main board (with its 8031) > > - Suggestions on how to proceed with setting to work / fault > > diagnosis > > - Has anyone house trained one of these to read PDP-11 absolute > > binary tapes, their target market was G code (text) > > > > Martin > > >
