Csr correct? Sent from my iPhone
> On May 23, 2025, at 16:58, Bill Degnan via cctalk <[email protected]> > wrote: > > Cable and termination? > >> On Fri, May 23, 2025 at 6:48 PM Peter Ekstrom via cctalk < >> [email protected]> wrote: >> >> Hello to the group, >> >> I have been banging my head against a PDP-11/23 where I have an RQDX3 I'm >> trying to get to work. Actually, I have two RQDX3's but only one at a time. >> It is configured to the factory CSR, 172150, and it has the latest >> microcode on it. When I run the XXDP ZRQCH0 formatter I get the following: >> >> RQDX3 Disk Formatter Utility >> UNIT IS Formattable Winchester (RDnn) or Floppy (RX33) Drives >> RSTRT ADR 145702 >> DR>STA >> >> >> CHANGE HW (L) ? Y >> >> >> >> >> # UNITS (D) ? 1 >> >> >> UNIT 0 >> Enter controller IP Address (O) 172150 ? >> What unit do you want to format [0-255] (D) 0 ? >> Would you like to revector a single LBN only [Y/N] (L) N ? >> Do you want to use the "AUTOFORMAT" Mode [Y/N] (L) Y ? N >> >> >> ZRQC SYS FTL ERR 00006 ON UNIT 00 TST 001 SUB 000 PC: 105742 >> Fatal Controller Error During Initialization. >> >> >> ZRQC SYS FTL ERR 00006 ON UNIT 00 TST 001 SUB 002 PC: 105742 >> Fatal Controller Error During Initialization. >> >> >> ZRQC EOP 1 >> 2 TOTAL ERRS >> >> >> DR> >> >> >> I have been booting XXDP and also RT11 over an emulator TU58. And I have a >> BDV11 so it has an LTC. >> >> I did try downgrading the microcode on the RQDX3 to the previous version, >> 3. It was 4. But no luck. >> Am I missing something? This should work with an M8186 CPU board, right? >> >> Anyone have any ideas? I haven't yet, but I plan to pop one of these RQDX3s >> in my 11/23+ and see if it works there. >> >> -Peter >>
