Hello,
I am trying to get an Emulex QD21 configured on a
MicroVAX-II. I am using the procedure in the manual for
"starting F.R.D. on a MicroVAX II". I have verified the
device addresses respond at the console commands for the
standard address.
The responses from the board are correct up until the last
examine command, where I should get an 0400 response at
2000146A, but I get 0200 instead. If I then examine 0080 I
get FFFF FFFF.
So, somehow the QD21 is not copying the diagnostic program
to the VAX memory.
Possibly there is a switch setting or jumper not set correctly.
I do have the original Emulex manual, and I did this
procedure successfully FORTY years ago!
Does anybody have suggestions on what I'm doing wrong?
Thanks,
Jon
