I just got a new Toshiba SD-R1002 CD-RW/DVD drive and went to use cdrdao
1.1.5 on it, only to get this error message:
> Executing power calibration...
> ?: Input/output error. : scsi sendcmd: no error
> CDB: 54 01 00 00 00 00 00 00 00 00
> status: 0x2 (CHECK CONDITION)
> Sense Bytes: 70 00 05 00 00 00 00 0A 00 00 00 00 20 00 00 00
> Sense Key: 0x5 Illegal Request, Segment 0
> Sense Code: 0x20 Qual 0x00 (invalid command operation code) Fru 0x0
> Sense flags: Blk 0 (not valid)
> cmd finished after 0.002s timeout 180s
> Power calibration not supported.
> Writing track 01 (mode MODE1/MODE1)...
The rest of the write session went just fine, and I could read the CD-R
in my CD-ROM drive. Still, should I be concerned? cdrecord 1.9 seems
to be just fine and dandy with its power calibration:
> Waiting for reader process to fill input buffer ... input buffer ready.
> Performing OPC...
> Starting new track at sector: 0
Is this a bug with cdrdao?
--
It has been justly observed by sages of all lands that although a man may be
most happily married and continue in that state with the utmost contentment,
it does not necessarily follow that he has therefore been struck stone-blind.
-- H. Warner Munn
Linux dpeng.student.princeton.edu 2.4.3-20mdk #1 Sun Apr 15 23:03:10 CEST 2001 i686
unknown
8:36pm up 7:14, 5 users, load average: 0.21, 0.47, 0.52
--
To UNSUBSCRIBE, email to [EMAIL PROTECTED]
with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
