You mention on your website that LG gave you a 8080B drive. I'm having some problems using it in Linux (Mandrake 8.2 on a 450Mhz PII) to burn CD-RW media. Here is the error that I get:
cdrecord: Input/output error. blank unit: scsi sendcmd: no error CDB: A1 00 00 00 00 00 00 00 00 00 00 00 status: 0x2 (CHECK CONDITION) Sense Bytes: 70 00 04 00 00 00 00 0A 00 00 00 00 09 00 00 00 Sense Key: 0x4 Hardware Error, Segment 0 Sense Code: 0x09 Qual 0x00 (track following error) Fru 0x0 Sense flags: Blk 0 (not valid) cmd finished after 4.746s timeout 9600s cdrecord: Cannot blank disk, aborting. This, incidentally, is the error that I get when I try to burn a CD-R Audio disk without DAO. When I include the -dao option, cdrecord seems to detect and fix the problem on its own: Performing OPC... Sending CUE sheet... cdrecord: WARNING: Drive returns wrong startsec (0) using -150 Writing pregap for track 1 at -150 ARG! Here is the -atip info for my drive: scsidev: '2,1,0' scsibus: 2 target: 1 lun: 0 Linux sg driver version: 3.1.22 Using libscg version 'schily-0.5' Device type : Removable CD-ROM Version : 0 Response Format: 1 Vendor_info : 'LG ' Identifikation : 'CD-RW CED-8080B ' Revision : '1.06' Device seems to be: Generic mmc CD-RW. Using generic SCSI-3/mmc CD-R driver (mmc_cdr). Driver flags : SWABAUDIO Supported modes: TAO PACKET SAO SAO/R96P SAO/R96R RAW/R16 RAW/R96P RAW/R96R ATIP info from disk: Indicated writing power: 3 Reference speed: 6 Is not unrestricted Is erasable Disk sub type: High speed Rewritable (CAV) media (1) ATIP start of lead in: -11635 (97:26/65) ATIP start of lead out: 337350 (75:00/00) speed low: 4 speed high: 8 power mult factor: 1 5 recommended erase/write power: 5 A2 values: 00 00 00 Disk type: Phase change Manuf. index: 3 Manufacturer: CMC Magnetics Corporation Any suggestions would be greatly appreciated. Sincerely, Nicholas Larson [EMAIL PROTECTED] -- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
