Bart Schaefer wrote:
On 8/13/07, Doug Coats <[EMAIL PROTECTED]> wrote:
I am having difficulty getting one of my machines to boot and assign
the same designation of eth0 and eth1 to the same nics consistantly.
I posted something about this back on April 25,
Message-ID: <[EMAIL PROTECTED]>
What I said then was:
--------
The problem (as I recall) is that on each reboot the onboard NICs are
being discovered in a different order, so the MAC addresses in
/etc/sysconfig/hwconf don't match what is recorded in
/etc/sysconfig/network-scripts/ifcfg-eth*.
I believe what I had to do (I should have written it down, damn it)
was hand-edit /etc/sysconfig/hwconf to completely remove all the
references to the NICs (there may be more than one entry for each NIC
because of the flip-flopping), edit ifcfg-eth* to remove all
references to HWADDR, reboot again to let the cards be rediscovered,
and then again hand-edit ifcfg-eth* to insert HWADDR lines that match
the device assignments in the regenerated /etc/sysconfig/hwconf.
However, I may have at least the last step of that wrong.
--------
No one ever responded as to whether that solution worked for them.
Did you try taking out the HWADDR lines in the ifcfg-eth* scripts
completely, and putting
alias eth0 xxx
alias eth1 yyy
in /etc/modules.conf where xxx and yyy are the modules for the
respective nics?
That should have worked in older versions, but I'm not sure if it still
does.
--
Les Mikesell
[EMAIL PROTECTED]
_______________________________________________
CentOS mailing list
CentOS@centos.org
http://lists.centos.org/mailman/listinfo/centos
