Hello All, I seem to have run into a bug with the new --bridgeslaves=<INTERFACE> option. It would seem that if I tell the bridge device to use a virtual interface (like bond0) rather than a physical interface (em1/em2) that kickstart completely barfs on it. I have provided my network section below which works fine as long as i don't enable all the bridge content.
When the installation starts off the creation of bond0 and all VLANs on bond0 go without issue. Jumping into TTY2 I can type 'ip a' and see all the bond0 device and bond0.VLANID devices no problem. When I enable bridge content with --bridgeslaves=bond0 or --bridgeslaves=bond0.VLANID anaconda barfs When I enable bridge content with --bridgeslaves=em1 or --bridgeslaves=em2 anaconda doesn't have an issue. Is this expected behaviour? I really don't want to have to manually manipulate the ifcfg-bond* interfaces and create the ifcfg-BRIDGE* interfaces manually so I'd like this to work. # Configure a bond over the slaves in failover mode network --device=bond0 --noipv6 --bootproto=dhcp --onboot=yes --bondslaves=em1,em2 --bondopts=mode=active-backup;primary=em1 --activate # Configure VLANs network --device=bond0 --vlanid=11 --noipv6 --onboot=yes --bootproto=dhcp --activate network --device=bond0 --vlanid=100 --noipv6 --onboot=yes --bootproto=dhcp --activate network --device=bond0 --vlanid=302 --noipv6 --onboot=yes --bootproto=dhcp --activate network --device=bond0 --vlanid=303 --noipv6 --onboot=yes --bootproto=dhcp --activate network --device=bond0 --vlanid=304 --noipv6 --onboot=yes --bootproto=dhcp --activate network --device=bond0 --vlanid=306 --noipv6 --onboot=yes --bootproto=dhcp --activate # Create a bridge on the bonded VLAN interfaces network --device=FASNET --bridgeslaves=bond0 network --device=GLUSTER --bridgeslaves=bond0.11 network --device=EXPERIMENTAL --bridgeslaves=bond0.302 network --device=NAT --bridgeslaves=bond0.303 network --device=DMZ2 --bridgeslaves=bond0.304 network --device=NETM --bridgeslaves=bond0.306 -- James A. Peltier IT Services - Research Computing Group Simon Fraser University - Burnaby Campus Phone : 604-365-6432 Fax : 778-782-3045 E-Mail : jpelt...@sfu.ca Website : http://www.sfu.ca/itservices Twitter : @sfu_rcg Powering Engagement Through Technology _______________________________________________ CentOS mailing list CentOS@centos.org http://lists.centos.org/mailman/listinfo/centos
