I recently had a failing disk replaced in my colo server. The server
is running Centos 7.3.
After the replacement, I was following these instructions to rebuild
the RAID array that the disk was part of.
Everything went fine until I reached the final section ("Grub Setup").
This section talks about running a command line program called "grub"
to change the Grub configuration. And that program doesn't seem to be
installed on this server.
I admit that my knowledge of Grub is somewhat lacking. I know that
Centos 7 uses Grub2 rather than the original Grub, but I don't know
what replaced the "grub" command (or perhaps nothing replaced it and I
just need to install a missing RPM).
Any advice would be gratefully received.
Dave Cross :: d...@dave.org.uk
CentOS mailing list