On 8 August 2017 at 10:56, Scott Robbins <scottr...@gmail.com> wrote:
> On Tue, Aug 08, 2017 at 09:01:30AM +0100, Dave Cross wrote:
>> I recently had a failing disk replaced in my colo server. The server
>> is running Centos 7.3.
>> After the replacement, I was following these instructions to rebuild
>> the RAID array that the disk was part of.
>> Everything went fine until I reached the final section ("Grub Setup").
>> This section talks about running a command line program called "grub"
>> to change the Grub configuration. And that program doesn't seem to be
>> installed on this server.
> grub2 install /dev/sda
> grub2 install /dev/sdb
> should do it, assuming the two actual physical disks are seen as
> /dev/sda and /dev/sdb
Thanks. That's what my independent research was showing me too.
I assume it's already installed to /dev/sda (as it was sdb which was
recently replaced and the system is rebooting quite happily). Is there
a command that shows which disks already have Grub2 installed?
Dave Cross :: d...@dave.org.uk
CentOS mailing list