I have a system who's normal activity is running Xen 3.3.1 with Centos 5.3 as
the DomU. I had reason to connect an IDE drive to the single IDE interface that
this board has. I was getting slow performance. hdparm -t revealed that the
thoughput was down to just 2.7 MB/sec. After some tweaking (switch on 32
bit,etc) and retesting under a non-Xen config, I managed to get that to
8MB/Sec. When I move the drive to a USB to IDE adapter, hdparm -t gives me
about 18MB/Sec. Big improvement, although I don't know if it is then perfect..
My kernel is 2.6.18-128.4.1.el5. I have kernel parameter pci=nomsi. I can't
remember exactly why I needed this, but there was a good reason, maybe SATA
drive not working properly or some such. Could this be the cause of my issue?
The motherboard blurb states that the IDE interface is ATA/133 compliant and I
am using the provided IDE cable. I have tried three hard disks, all with
similar results. (2x 40gb + 1x 160gb)
lspci | grep IDE gives
00:06.0 IDE interface: nVidia Corporation MCP78S [GeForce 8200] IDE (rev a1)
As a reference, hdparm -t against the SATA drive in AHCI mode on the same board
gives about 110MB/Sec.
Any ideas, anyone?
Thanks in advance,
Ian.
_______________________________________________
CentOS mailing list
[email protected]
http://lists.centos.org/mailman/listinfo/centos
