I tried to change the configuration of a compatible sata in bios to AHCI, but
my hard drive is not detected.
I do not have a smart array controller. I do this AHCI features need smart
array controller? I've been looking for a reference, but did not find.
Any suggestions?
--
Best regards,
David
http://blog.pnyet.web.id
On 05/12/2010 02:52 AM, Christoph Maser wrote:
Am Dienstag, den 11.05.2010, 11:38 +0530 schrieb Rajagopal Swaminathan:
Greetings,
On Tue, May 11, 2010 at 8:08 AM, David Suhendrik<da...@pnyet.web.id> wrote:
@Rajagopal:
This result:
# hdparm -tT /dev/hda5
/dev/hda5:
Timing buffered disk reads: 8 MB in 3.08 seconds = 2.60 MB/sec
First of all it should report /dev/sda and not /dev/hda
It is a horrible speed for modern disks.
Modern SATA disks show around 50-80 MB/Sec
I am sure ide0noprobe=no (or zero -- check docs) in the kernel mline
will surely speed up in addition to other suggestions will
dramatically speed up.
As will setting the operation mode in mode in BIOS from compatible to
SATA. First thing i do on all HP servers when they are shipped.
Chris
_______________________________________________
CentOS mailing list
CentOS@centos.org
http://lists.centos.org/mailman/listinfo/centos
_______________________________________________
CentOS mailing list
CentOS@centos.org
http://lists.centos.org/mailman/listinfo/centos
