CentOS 6.2.........
Why do the physical interfaces report (correctly) that they're negotiated at
1000Mb/s, but when I `cat /proc/net/bonding/bond0` I get 100Mbps for the member
interfaces, and when I ` mii-tool bond0` I get 10Mbps for the bond?
-----------------------------------------------------------------------------------------
ethtool em1
Settings for em1:
Supported ports: [ TP ]
Supported link modes: 10baseT/Half 10baseT/Full
100baseT/Half 100baseT/Full
1000baseT/Full
Supports auto-negotiation: Yes
Advertised link modes: 10baseT/Half 10baseT/Full
100baseT/Half 100baseT/Full
1000baseT/Full
Advertised pause frame use: No
Advertised auto-negotiation: Yes
Speed: 1000Mb/s
Duplex: Full
Port: Twisted Pair
PHYAD: 1
Transceiver: internal
Auto-negotiation: on
MDI-X: Unknown
Supports Wake-on: g
Wake-on: d
Link detected: yes
ethtool em2
Settings for em2:
Supported ports: [ TP ]
Supported link modes: 10baseT/Half 10baseT/Full
100baseT/Half 100baseT/Full
1000baseT/Full
Supports auto-negotiation: Yes
Advertised link modes: 10baseT/Half 10baseT/Full
100baseT/Half 100baseT/Full
1000baseT/Full
Advertised pause frame use: No
Advertised auto-negotiation: Yes
Speed: 1000Mb/s
Duplex: Full
Port: Twisted Pair
PHYAD: 1
Transceiver: internal
Auto-negotiation: on
MDI-X: Unknown
Supports Wake-on: g
Wake-on: d
Link detected: yes
-------------------------------------------------------------------------------------------------------------------
cat /proc/net/bonding/bond0
Ethernet Channel Bonding Driver: v3.6.0 (September 26, 2009)
Bonding Mode: load balancing (round-robin)
MII Status: up
MII Polling Interval (ms): 0
Up Delay (ms): 0
Down Delay (ms): 0
Slave Interface: em1
MII Status: up
Speed: 100 Mbps
Duplex: full
Link Failure Count: 0
Permanent HW addr: XX:XX:XX:XX:XX:XX
Slave queue ID: 0
Slave Interface: em2
MII Status: up
Speed: 100 Mbps
Duplex: full
Link Failure Count: 0
Permanent HW addr: XX:XX:XX:XX:XX:XX
Slave queue ID: 0
---------------------------------------------------------------------------------------------------
mii-tool bond0
bond0: 10 Mbit, half duplex, link ok
This e-mail transmission contains information that is confidential and may be
privileged. It is intended only for the addressee(s) named above. If you
receive this e-mail in error, please do not read, copy or disseminate it in any
manner. If you are not the intended recipient, any disclosure, copying,
distribution or use of the contents of this information is prohibited. Please
reply to the message immediately by informing the sender that the message was
misdirected. After replying, please erase it from your computer system. Your
assistance in correcting this error is appreciated.
_______________________________________________
CentOS mailing list
[email protected]
http://lists.centos.org/mailman/listinfo/centos
