Was probably an over-paranoid question. The upgrade 13.2.2 -> 13.2.8 went
smoothly. Only this one didn't do what was expected:
# ceph osd set pglog_hardlimit
Invalid command: pglog_hardlimit not in
full|pause|noup|nodown|noout|noin|nobackfill|norebalance|norecover|noscrub|nodeep-scrub|notieragent|nosnaptrim|sortbitwise|recovery_deletes|require_jewel_osds|require_kraken_osds
osd set
full|pause|noup|nodown|noout|noin|nobackfill|norebalance|norecover|noscrub|nodeep-scrub|notieragent|nosnaptrim|sortbitwise|recovery_deletes|require_jewel_osds|require_kraken_osds
{--yes-i-really-mean-it} : set <key>
Error EINVAL: invalid command
Not sure if this means anything problematic.
Best regards,
=================
Frank Schilder
AIT Risø Campus
Bygning 109, rum S14
________________________________________
From: Frank Schilder <[email protected]>
Sent: 31 January 2020 11:08:35
To: ceph-users
Subject: [ceph-users] Upgrading mimic 13.2.2 to mimic 13.2.8
Dear all,
is it possible to upgrade from 13.2.2 directly to 13.2.8 after setting "ceph
osd set pglog_hardlimit" (mimic 13.2.5 release notes), or do I need to follow
this path:
13.2. 2 -> 5 -> 6 -> 8 ?
Thanks!
=================
Frank Schilder
AIT Risø Campus
Bygning 109, rum S14
_______________________________________________
ceph-users mailing list -- [email protected]
To unsubscribe send an email to [email protected]
_______________________________________________
ceph-users mailing list -- [email protected]
To unsubscribe send an email to [email protected]
