It seems good with master branch. Sorry about the confusion. On a side note, is it possible to create/access the block device using librbd and run fio on it?
Thanks, Sushma -----Original Message----- From: Gregory Farnum [mailto:[email protected]] Sent: Tuesday, March 11, 2014 2:00 PM To: Sushma Gurram Cc: [email protected] Subject: Re: [ceph-users] qemu-rbd On Tue, Mar 11, 2014 at 1:38 PM, Sushma Gurram <[email protected]> wrote: > Hi, > > > > I'm trying to follow the instructions for QEMU rbd installation at > http://ceph.com/docs/master/rbd/qemu-rbd/ > > > > I tried to write a raw qemu image to ceph cluster using the following > command > > qemu-img convert -f raw -O raw ../linux-0.2.img rbd:data/linux > > > > OSD seems to be working, but it seems to take forever. However, an rbd > image seems to be created in the cluster's data pool. Okay, so it's creating the image in the data pool because that's what you told it to. Are you saying it seems hung, or just slow? > > When I use the newly created rbd image, it goes a little further in > boot and hangs. Looks like the entire image was not written. Did you wait for qemu-img to finish? -Greg Software Engineer #42 @ http://inktank.com | http://ceph.com ________________________________ PLEASE NOTE: The information contained in this electronic mail message is intended only for the use of the designated recipient(s) named above. If the reader of this message is not the intended recipient, you are hereby notified that you have received this message in error and that any review, dissemination, distribution, or copying of this message is strictly prohibited. If you have received this communication in error, please notify the sender by telephone or e-mail (as shown above) immediately and destroy any and all copies of this message in your possession (whether hard copies or electronically stored copies). _______________________________________________ ceph-users mailing list [email protected] http://lists.ceph.com/listinfo.cgi/ceph-users-ceph.com
