Unfortunately, I can't help much. I'm just using the S3 interface for object storage.
Looking back at the archives, this question does come up a lot, and there aren't a lot of replies. The best thread I see in the archive is http://lists.ceph.com/pipermail/ceph-users-ceph.com/2013-November/006283.html . Sébastien Han wrote Well after restarting the services run: $ cinder create 1 Then you can check both status in Cinder and Ceph: For Cinder run: $ cinder list For Ceph run: $ rbd -p <cinder-pool> ls If the image is there, you’re good. Cheers. There is some follow up in the thread, so you might want to read the whole discussion. On Thu, Jun 19, 2014 at 12:38 AM, Vickey Singh <[email protected]> wrote: > Hello Craig > > I am following you up on ceph mailing list, looks like you are the expert > for CEPH RGW. can you please guide me here. > > Thanks in advance for your help. > > - Vickram - > > > ---------- Forwarded message ---------- > From: Vickey Singh <[email protected]> > Date: Wed, Jun 18, 2014 at 7:57 PM > Subject: RADOSGW + OpenStack basic question > To: [email protected] > > > Hello Cephers > > > I have been following ceph documentation to install and configure RGW and > fortunately everything went fine and RGW is correctly setup. > > Next i would like to use RGW with OpenStack , and for this i have followed > http://ceph.com/docs/master/radosgw/keystone/ , as per the document i > have done all the steps. > > But how should i test RGW and OpenStack integration , the document does > not show steps to verify the integration or how to use it further with > openstack. > > Can you please point me to the right direction , for testing Ceph RGW and > OpenStack integration . Is there any work / blog on internet by > someone which can demonstrate the things “How to use Ceph RGW with > Openstack" > > Please help. > > > Regards > Vickram Singh > >
_______________________________________________ ceph-users mailing list [email protected] http://lists.ceph.com/listinfo.cgi/ceph-users-ceph.com
