When you lose a host, the entire CRUSH map is affected. Any change to the crush map can affect any PG, OSD, host, or failure domain in the entire cluster. If you modified osd.10's weight in the crush map by increasing it by 0.5, you would likely see PGs in the entire cluster moving around, not just PGs going onto and moving off of osd.10. Would that match what you're seeing?
You can do a full `ceph pg dump` and see if any of the PGs are showing that they are reflecting that they are running on multiple OSDs inside of the same failure domain. On Tue, May 30, 2017 at 12:34 PM Laszlo Budai <las...@componentsoft.eu> wrote: > Hello David, > > Thank you for your message. > > Indeed we were expecting to see the PGs from the lost host redistributed > to the surviving host from the same chassis (failure domain), but the > reality is different :( > I can see a lot of PGs being stuck active+undersized+degraded and > active+remapped. And for some of the remapped PGs I can see OSDs from the > same failure domain. > > We were able to reproduce the situation on a small test cluster also. So I > think this is a bug in hammer. The small test cluster has reacted properly > to failure when running Jewel. > > Kind regards, > Laszlo > > On 30.05.2017 17:31, David Turner wrote: > > If you lose 1 of the hosts in a chassis, or a single drive, the pgs from > that drive/host will be distributed to other drives in that chassis > (because you only have 3 failure domains). That is to say that if you lose > tv-c1-al01 then all of the pgs and data that were on that will be > distributed to tv-c1-al02. The reason for that is that you only have 3 > failure domains and replica size 3. > > > > If you lost both tv-c1-al01 and tv-c1-al02, then you would run with only > 2 copies of your data until you brought up a third failure domain again. > Ceph would never place 2 copies of your data inside of 1 failure domain. > > > > I recommend not to run in production with less than N+2 failure domains > where N is your replica size. It allows for more efficient data redundancy > and you can utilize a higher % of your total capacity. If you have 4 > failure domains, the plan is to be able to survive losing 1 of them... > Which means you shouldn't use more than ~55% of your total capacity because > of you lose a node, that 55% of 4 nodes becomes 73% of 3 nodes. Few > clusters are balanced well enough to handle 73% full without individual > osds going above 80%. 3 failure domains can work if you replace failed > storage quickly. > > > > > > On Mon, May 29, 2017, 12:07 PM Laszlo Budai <las...@componentsoft.eu > <mailto:las...@componentsoft.eu>> wrote: > > > > Dear all, > > > > How should ceph react in case of a host failure when from a total of > 72 OSDs 12 are out? > > is it normal that for the remapping of the PGs it is not following > the rule set for in the crush map? (according to the rule the OSDs should > be selected from different chassis). > > > > in the attached file you can find the crush map, and the results of: > > ceph health detail > > ceph osd dump > > ceph osd tree > > ceph -s > > > > I can send the pg dump in a separate mail on request. Its compressed > size is exceeding the size accepted by this mailing list. > > > > Thank you for any help/directions. > > > > Kind regards, > > Laszlo > > > > On 29.05.2017 14:58, Laszlo Budai wrote: > > > > > > Hello all, > > > > > > We have a ceph cluster with 72 OSDs distributed on 6 hosts, in 3 > chassis. In our crush map the we are distributing the PGs on chassis > (complete crush map below): > > > > > > # rules > > > rule replicated_ruleset { > > > ruleset 0 > > > type replicated > > > min_size 1 > > > max_size 10 > > > step take default > > > step chooseleaf firstn 0 type chassis > > > step emit > > > } > > > > > > We had a host failure, and I can see that ceph is using 2 OSDs > from the same chassis for a lot of the remapped PGs. Even worse, I can see > that there are cases when a PG is using two OSDs from the same host like > here: > > > > > > 3.5f6 37 0 4 37 0 149446656 > 3040 3040 active+remapped 2017-05-26 11:29:23.122820 > 61820'222074 61820:158025 [52,39] 52 [52,39,3] 52 > 61488'198356 2017-05-23 23:51:56.210597 61488'198356 2017-05-23 > 23:51:56.210597 > > > > > > I have tis in the log: > > > 2017-05-26 11:26:53.244424 osd.52 10.12.193.69:6801/7044 < > http://10.12.193.69:6801/7044> 1510 : cluster [INF] 3.5f6 restarting > backfill on osd.39 from (0'0,0'0] MAX to 61488'203000 > > > > > > > > > What can be wrong? > > > > > > > > > Our crush map looks like this: > > > > > > # begin crush map > > > tunable choose_local_tries 0 > > > tunable choose_local_fallback_tries 0 > > > tunable choose_total_tries 50 > > > tunable chooseleaf_descend_once 1 > > > tunable straw_calc_version 1 > > > > > > # devices > > > device 0 osd.0 > > > device 1 osd.1 > > > device 2 osd.2 > > > device 3 osd.3 > > > .... > > > device 69 osd.69 > > > device 70 osd.70 > > > device 71 osd.71 > > > > > > # types > > > type 0 osd > > > type 1 host > > > type 2 chassis > > > type 3 rack > > > type 4 row > > > type 5 pdu > > > type 6 pod > > > type 7 room > > > type 8 datacenter > > > type 9 region > > > type 10 root > > > > > > # buckets > > > host tv-c1-al01 { > > > id -7 # do not change unnecessarily > > > # weight 21.840 > > > alg straw > > > hash 0 # rjenkins1 > > > item osd.5 weight 1.820 > > > item osd.11 weight 1.820 > > > item osd.17 weight 1.820 > > > item osd.23 weight 1.820 > > > item osd.29 weight 1.820 > > > item osd.35 weight 1.820 > > > item osd.41 weight 1.820 > > > item osd.47 weight 1.820 > > > item osd.53 weight 1.820 > > > item osd.59 weight 1.820 > > > item osd.65 weight 1.820 > > > item osd.71 weight 1.820 > > > } > > > host tv-c1-al02 { > > > id -3 # do not change unnecessarily > > > # weight 21.840 > > > alg straw > > > hash 0 # rjenkins1 > > > item osd.1 weight 1.820 > > > item osd.7 weight 1.820 > > > item osd.13 weight 1.820 > > > item osd.19 weight 1.820 > > > item osd.25 weight 1.820 > > > item osd.31 weight 1.820 > > > item osd.37 weight 1.820 > > > item osd.43 weight 1.820 > > > item osd.49 weight 1.820 > > > item osd.55 weight 1.820 > > > item osd.61 weight 1.820 > > > item osd.67 weight 1.820 > > > } > > > chassis tv-c1 { > > > id -8 # do not change unnecessarily > > > # weight 43.680 > > > alg straw > > > hash 0 # rjenkins1 > > > item tv-c1-al01 weight 21.840 > > > item tv-c1-al02 weight 21.840 > > > } > > > host tv-c2-al01 { > > > id -5 # do not change unnecessarily > > > # weight 21.840 > > > alg straw > > > hash 0 # rjenkins1 > > > item osd.3 weight 1.820 > > > item osd.9 weight 1.820 > > > item osd.15 weight 1.820 > > > item osd.21 weight 1.820 > > > item osd.27 weight 1.820 > > > item osd.33 weight 1.820 > > > item osd.39 weight 1.820 > > > item osd.45 weight 1.820 > > > item osd.51 weight 1.820 > > > item osd.57 weight 1.820 > > > item osd.63 weight 1.820 > > > item osd.70 weight 1.820 > > > } > > > host tv-c2-al02 { > > > id -2 # do not change unnecessarily > > > # weight 21.840 > > > alg straw > > > hash 0 # rjenkins1 > > > item osd.0 weight 1.820 > > > item osd.6 weight 1.820 > > > item osd.12 weight 1.820 > > > item osd.18 weight 1.820 > > > item osd.24 weight 1.820 > > > item osd.30 weight 1.820 > > > item osd.36 weight 1.820 > > > item osd.42 weight 1.820 > > > item osd.48 weight 1.820 > > > item osd.54 weight 1.820 > > > item osd.60 weight 1.820 > > > item osd.66 weight 1.820 > > > } > > > chassis tv-c2 { > > > id -9 # do not change unnecessarily > > > # weight 43.680 > > > alg straw > > > hash 0 # rjenkins1 > > > item tv-c2-al01 weight 21.840 > > > item tv-c2-al02 weight 21.840 > > > } > > > host tv-c1-al03 { > > > id -6 # do not change unnecessarily > > > # weight 21.840 > > > alg straw > > > hash 0 # rjenkins1 > > > item osd.4 weight 1.820 > > > item osd.10 weight 1.820 > > > item osd.16 weight 1.820 > > > item osd.22 weight 1.820 > > > item osd.28 weight 1.820 > > > item osd.34 weight 1.820 > > > item osd.40 weight 1.820 > > > item osd.46 weight 1.820 > > > item osd.52 weight 1.820 > > > item osd.58 weight 1.820 > > > item osd.64 weight 1.820 > > > item osd.69 weight 1.820 > > > } > > > host tv-c2-al03 { > > > id -4 # do not change unnecessarily > > > # weight 21.840 > > > alg straw > > > hash 0 # rjenkins1 > > > item osd.2 weight 1.820 > > > item osd.8 weight 1.820 > > > item osd.14 weight 1.820 > > > item osd.20 weight 1.820 > > > item osd.26 weight 1.820 > > > item osd.32 weight 1.820 > > > item osd.38 weight 1.820 > > > item osd.44 weight 1.820 > > > item osd.50 weight 1.820 > > > item osd.56 weight 1.820 > > > item osd.62 weight 1.820 > > > item osd.68 weight 1.820 > > > } > > > chassis tv-c3 { > > > id -10 # do not change unnecessarily > > > # weight 43.680 > > > alg straw > > > hash 0 # rjenkins1 > > > item tv-c1-al03 weight 21.840 > > > item tv-c2-al03 weight 21.840 > > > } > > > root default { > > > id -1 # do not change unnecessarily > > > # weight 131.040 > > > alg straw > > > hash 0 # rjenkins1 > > > item tv-c1 weight 43.680 > > > item tv-c2 weight 43.680 > > > item tv-c3 weight 43.680 > > > } > > > > > > # rules > > > rule replicated_ruleset { > > > ruleset 0 > > > type replicated > > > min_size 1 > > > max_size 10 > > > step take default > > > step chooseleaf firstn 0 type chassis > > > step emit > > > } > > > > > > # end crush map > > > > > > > > > Thank you, > > > Laszlo > > > _______________________________________________ > > > ceph-users mailing list > > > ceph-users@lists.ceph.com <mailto:ceph-users@lists.ceph.com> > > > http://lists.ceph.com/listinfo.cgi/ceph-users-ceph.com > > > > > _______________________________________________ > > ceph-users mailing list > > ceph-users@lists.ceph.com <mailto:ceph-users@lists.ceph.com> > > http://lists.ceph.com/listinfo.cgi/ceph-users-ceph.com > > >
_______________________________________________ ceph-users mailing list ceph-users@lists.ceph.com http://lists.ceph.com/listinfo.cgi/ceph-users-ceph.com
