Cheers for that, I managed to figure it out late last night finally. One things for sure, CF Report Builder is quite underrated I reckon. Never even looked at it in the past, and am now considering it for all sorts of things.
Neil On 6/20/06, Kay Smoljak <[EMAIL PROTECTED]> wrote: > > On 6/20/06, Neil Middleton <[EMAIL PROTECTED]> wrote: > > I've been building up a load of spec sheets for cars using the > Coldfusion > > report builder, but I need to add is a cover sheet on the report, so I > can > > just print out the whole PDF, then stick it in an envelope and send it > off. > > If you create a report header band (rather than a page header) you can > set a page break after it... check out the property sheet for the top > level, there's an option there for page break after report header and > page break before report footer. > > If you want to be able to print all the reports together as one, > that's a bit trickier, you'll need to embed each of the reports as a > subreport of the main report. There's no conditional control of > margins etc so the subreports will need to not have any. If you put > each of the subreports in their own grouping band with a min height > same as the page height, you'll get each of them starting on a new > page. > > I should blog some of this stuff :) > > K. > > -- > Kay Smoljak > http://kay.smoljak.com/ > > ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~| Message: http://www.houseoffusion.com/lists.cfm/link=i:4:244215 Archives: http://www.houseoffusion.com/cf_lists/threads.cfm/4 Subscription: http://www.houseoffusion.com/lists.cfm/link=s:4 Unsubscribe: http://www.houseoffusion.com/cf_lists/unsubscribe.cfm?user=89.70.4 Donations & Support: http://www.houseoffusion.com/tiny.cfm/54
