> Does CF5 allow you to specify a range of IP addresses to receive
> debugging info? Everytime I log into our network I get a different
> IP in our range... so then I have to turn it on to all IPs, then
> find out what mine is and set it to allow just that. It's really
> annoying. And I don't want to manually put in all the possible
> values I could have because that would be a nightmare.
No, CF 5 doesn't support that, unfortunately. However, it does support you
adding your own IP address automatically. There's a button in the
Administrator "Debugging IPs" screen labeled "Add Current", which will add
your IP address to the list, so you don't have to figure out what your IP
address is. I'm very proud of that button - it's my only personal
contribution to the CF 5 Administrator interface.
In addition, your DHCP administrator might be able to make your life a
little easier with DHCP reservations, so that you get the same IP address
every time you connect to the network, based on your MAC address. This is
pretty easy to set up, although a bit tedious.
Dave Watts, CTO, Fig Leaf Software
http://www.figleaf.com/
phone: (202) 797-5496
fax: (202) 797-5444
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
Structure your ColdFusion code with Fusebox. Get the official book at
http://www.fusionauthority.com/bkinfo.cfm
Archives: http://www.mail-archive.com/[email protected]/
Unsubscribe: http://www.houseoffusion.com/index.cfm?sidebar=lists
