Re: [Chevelle-List] Spark plugs & Resistor wire.

[Michael Pell]

Replies to this message are sent to The Chevelle Mailing List ------------------------------------------------------------ Why do you say the tune-up will last longer? Thanks, Rob Thorburn wrote: Good points Rich! (pun) I would also like to add, take the time to cut the plug wires to the correct length, loom those plug wires to keep them away from each other and ground.  Never tie strap them to the valve covers or tie strap them together.  I buy several of the looming kits, and use one for every couple of inchs of plug wire.  The reward is; the tuneup will last much longer. Rob ----- Original Message ----- From: Richard Milkiewicz To: CHEVELLE Sent: Friday, December 07, 2001 7:38 AM Subject: [Chevelle-List] Spark plugs & Resistor wire.  Let me try and clear up some confusion. First, I'm not an expert on this but I do have some knowledge on the subject.The HEI was was installed across the GM car line in 1975 through 1980. After that computer controlled HEI's came in. The main difference being the external vacume advance housing. Conventional point dist. can only handle 2.5 amps before burning up. The HEI can handle 4 amps. More amps, better coil saturation. Since the HEI needs a full 12 volts to run efficiently (unlike points, 8 volts) you MUST lose the resistance wire. The HEI can produce 35000 + volts but it needs the full 12 volts to do this. (coil saturation) The resistor wire causes a voltage drop after starting. During starting it is by-passed. This wire is what kept the points from burning up. Keith is right about the PINK wire. But don't make it too long. The longer the path, the less voltage. As for spark plugs and the HEI, you should be sure to use the right application.  Plugs designed for conventional ignitions should not be used because when you open the gap you are really bending the electrode at an angle. To fire efficiently the ground electrode should be flat over the center electrode. HEI plugs have a shorter center electrode. And this allows for the larger gap. Larger gap, longer spark. And don't over look the plug wires. You need at least 8mm wire. Use a good silicone and wipe the inside of the plug and dist. boot. It not only keeps moisture out but helps keep voltage loss down. Not to mention easier boot removal. A very good book I bought several years ago was "IGNITION / ELECTRICITY BOOK by Dr. Christopher Jacobs. It may still be available. I think it cost around 15 bucks. Hope this small bit of info helps everyone.Rich --   Check out my webpage at http://www.ProStreetCar.com   and my For Sale page at http://www.ProStreetCar.com/classifieds.html   Team Chevelle membership #178 (Gold)   Time Flies: "It's funny how you can watch a clock and time seems to   stand still.  But turn away, and you have to measure time with a   calendar rather than a clock."  mjp   ----------------------------------------------------- To Unsubscribe please visit www.chevelles.net/list.html To start a new topic, send mail to: [EMAIL PROTECTED]