|
Hi Larry,
I'm not sure if I mentioned doing this to my Elky, but yes I did it.
I used a dremel with those tiny little cutoff wheels (I must've went through 100
or more) and trimmed the inner fender lips so there was about a 1/4" left.
Then I used a hammer and dolly to roll the 1/4" lip up. When I was
finished I had a lot more tire clearance, but the outside of the
fender looked like crap. Fortunately the body shop was able to make
it pretty again.
I later learned a different way to do it. Cut the lip into 1"
sections with the cutoff wheel, then it will be much easier to fold/roll
each section up and out of the way. HTH.
cYa-
|
- [Chevelle-List] Roll inside of rear fenders. Larry Brown
- Herbert Lumpp
