|
Rich,
I'd like a set
too.
Thanks,
Dean
Vandergriff
-----Original
Message-----
From: Richard Milkiewicz [mailto:[EMAIL PROTECTED]]
Sent: Wednesday, January 15, 2003 10:56 AM
To:
[EMAIL PROTECTED]
Subject: Re: [Chevelle-List] blasting a
body
Never mind, I found them and will send them out
to all who wanted it.
Rich
"66 Malibu
ACES # 5066
----- Original Message -----
Sent: Wednesday, January 15, 2003 11:27
AM
Subject: Re: [Chevelle-List] blasting a
body
Well, I thought I knew where the instructions
were for the rotisserie. I'll find them this week end and send them to all
who wanted them.
Rich
"66 Malibu
ACES # 5066
----- Original Message -----
Sent: Wednesday, January 15, 2003
6:58 AM
Subject: Re: [Chevelle-List] blasting
a body
can i get those pics?
thanks
----- Original Message -----
Sent: Wednesday, January 15, 2003
6:46 AM
Subject: RE: [Chevelle-List]
blasting a body
I just finished building one. It was a piece of cake.
The steel was $178 all cut and ready to go. The worst part is
drilling all the holes. If you want pictures let me know. I
did make a little adjustment, added 2 hyd cyl to raise and lower it on
the uprights.
Jim Buckingham
Would you send those plans to a South Carolinan?
Smitty
----- Original Message -----
Sent: Tuesday, January 14, 2003
10:17 AM
Subject: Re: [Chevelle-List]
blasting a body
Kyle, If you want to build a
rotisserie, I have plans I can send you.
Rich
"66 Malibu
ACES #
5066
----- Original Message -----
Sent: Tuesday, January 14,
2003 9:41 AM
Subject: Re: [Chevelle-List]
blasting a body
what did you pay do have that
done?
Kyle Bennett
Raleigh, NC
----- Original Message -----
Sent: Tuesday, January 14,
2003 6:27 AM
Subject: Re:
[Chevelle-List] blasting a body
The fastest, safest and best way to
strip a car is acid dip. It will cost about the same as media
blasting. Maybe a little more. They don't use sand. Sandblasting
is one of those universal words everyone uses to describe what
they want done. They do sandblast the frame, I'll get mine done
this spring. Acid dipping will get in every nook and cranny and
remove EVERYTHING. Rust, grease, paint, sealer, etc. But you get
back virgin looking steel. They bake it in an oven to melt and
loosen everything then dip it and then it is run through a
neutralizing bath. Just had mine done and I couldn't be
happier with it. The solid floors I thought I had...... well
their not so solid. I have to replace two small sections in
front. Right where the air conditioner was. I had a Mustang
media blasted once and it turned out to be a nightmare. It will
punch holes in weaker metal even if there are no holes there
now.
Rich
"66 Malibu
ACES #
5066
----- Original Message -----
Sent: Monday, January 13,
2003 12:26 PM
Subject: [Chevelle-List]
blasting a body
Typically, How much does it cost
to have a body sand blasted? I'm trying to decide if i want to
rent a Rotissorie (sp?) and do it my self, of just let
somebody else do it.
Thanks,
Kyle Bennett
Raleigh, NC
|
