Re: [Chevelle-List] Driveshaft help... eek!

[Matthew Post]

I did a 350/TH350 to 396/TH400 swap a few years ago on my '69.  I had the 
TH350 driveshaft shortened and the TH400 yoke put on it.  I'm not sure by 
how much it was shortened, but I can measure how long it is now.  At the 
time, I just told my driveshaft shop the swap I was doing and they had the 
measurements.  The crossmember will work, you just have to use frame wholes 
that are further back.  And I think the tranny mount is the same.  Someone 
can correct me if I'm wrong about that.

Matt

At 06:02 PM 6/16/2003 -0500, you wrote:
Well we have the th350 to th400 swap going here and just wanted to see if 
anyone had the measurment or even if anyone had a th400 drive shaft for a 
68 model. I know the yoke is different and it needs the elec kickdown... 
But will the same crossmember work? Does it require a different tranny 
mount? Thanks for the help fellas... keep finding kinda vauge and conunter 
dicting info on this so figured I'd see if any listers have done it or can 
help.

Gotta get my beast ready to rock for the Car Craft Summer Nationals in 
mid-july :)

Mikey


-----------------------------------------------------
To Unsubscribe please visit www.chevelles.net/list.html
To start a new topic, send mail to: [EMAIL PROTECTED]