Re: [Chevelle-list] Trunk replacement

[Mike Holleman]

I just finished that exact job on a 64 Skylark. From the kit I used the three floor panels and the tank braces. The body braces were in great shape so I did not disturb them. You will have to make some choices as to where you will cut and fit your panels. Where you have bad and good metal to tie in to. I went full width, about half way up the hump in the front and pretty much full in the rear except to cut away for clearance around the bracing. While I weld most of the panels in, I use a product called Fuzor body panel glue to bond the panels to each other. It works great to bond flat clean overlapped panels. I screw the panels together until the glue drys and then weld in the holes made by the screws. Made for a very clean installation with easy to cover seams. Mike Holleman ----- Original Message ----- From: [EMAIL PROTECTED] To: [EMAIL PROTECTED] Sent: Wednesday, December 17, 2003 10:49 PM Subject: [Chevelle-list] Trunk replacement Has any one installed 3 piece trunk replacement panels with body brace? Are there any other braces needed 65Malibu SS, info needed to hang gas tank also Thanks Phil