Hey guys: Great way to start my morning by laughing out loud!!
Soon as I saw "Remove me" "And let the games begin" I knew what was coming.  I Love 
it!!!!!!!  This list is the greatest!  Technical, enjoyable, entertaining, and at 
times political & heart warming.  Got to have a sense of humor to get through life.  
Especially grown men with expensive grown-up toys.  I don't play golf but I do spend 
most spring to fall weekends with my car.  Been 17 for almost 39 years now!  Don't 
ever quit guys.  Leave the List!  NEVER!!!!!!!!!!!

Phil G.  65 SS     








In a message dated 6/21/2004 8:04:20 PM Eastern Daylight Time, [EMAIL PROTECTED] 
writes:

> Perfect!
> 
> Bill Lessenberry wrote:
> 
> At 06:33 PM 6/21/2004, you wrote:
> 
> let the games begin!
> 
> Alan Moore <[EMAIL PROTECTED]> wrote: 
> 
> Remove me please!!
> 
> Well OKden
> 
> To unsubscribe from this service you must first 
> purchase a 
> Craft-O-Matic Adjustable Subscription Cancellation 
> Unit. The unit can be 
> obtained from most hardware stores and dental clinics. 
> Be sure to obtain the proper permits to operate the 
> unit from the 
> Nuclear Regulatory Commission and the Food and Drug 
> Administration in 
> Washington D.C. USA. 
> Be sure to carefully unpack the kit and place each 
> component in its 
> accompanying mesh safety bag. 
> Mount the Pershing DF4 mesinator on top of the 
> perforated Gerring Mach 
> 77 refibulator and attach them using the 
> eight-millimeter torque fork. 
> Be sure that the refibulator is mounted at a 66 degree 
> angle and 
> properly dispersed so that it is flush with the curved 
> section of the 
> Pyrex thistle tube. 
> Place the four sections of the triangular separation 
> gear into the 
> posture cylinder and lock them into place using the 
> band aid adhesive strip. 
> Insert the wiggling pin into the wobbling hole, making 
> sure that it 
> seated correctly. 
> Place the D cell battery and the eleven 9 volt 
> batteries in the power 
> chamber. 
> The device should be calibrated before operation using 
> the optional 
> digital corkscrew accessory pack prior to operation. 
> Insert the digital corkscrew through the electronic 
> combustion service 
> chamber using caution not to touch the reinforced 
> tungsten igniter 
> control module and quickly turn the inverter drive to 
> 28.6 degrees. 
> Turn the Craft-O-Matic Adjustable Subscription 
> Cancellation Unit upside 
> down and hit the bottom plate with a 48-ounce 
> ball-peen hammer while 
> shaking the unit vigorously. 
> Force open the door to the incineration valve 
> compartment and set the 
> pressure gauge to 719 psi. 
> Close the door and seal it shut with duct tape. 
> The unit should now be properly calibrated and ready 
> to use. 
> Before activating the Craft-O-Matic Adjustable 
> Subscription 
> Cancellation Unit, you must first elevate it to a 
> height of 229 feet 
> above sea level to insure that the unit receives the 
> proper oxygen level 
> and barometric pressure. 
> Point the aerial to 17 degrees north by northeast to 
> within the 
> parameters of the Telstar GS-2 weather satellite and 
> apply pressure to 
> the wing shaft on the southern most section of the 
> modular accelerator. 
> Using the special ratchet adapter supplied with the 
> unit, rotate the 
> heater core to the "on" position. The "on" position 
> has been obtained 
> when the green light begins to flash, signifying that 
> the red light is 
> about to go off. 
> Once the red light is off, flip the toggle switch 
> labeled "ON/OFF" to 
> the "ON" position and count to 47 before logging on to 
> the system. 
> Logon using your username and password and wait for 
> the prompt. 
> Once prompted you must check the box with the 
> appropriate action you 
> wish to take and then press the pressure release 
> button and turn off the 
> compressor while turning the hand crank at 231 meters 
> per minute. 
> Next, press control, alt, delete, caps lock, shift, 
> number lock, escape 
> and tab simultaneously. 
> Press enter. You will have one second to complete the 
> procedure. 
> If you fail to respond in the time limit allowed, 
> simply purchase a new 
> Craft-O-Matic Adjustable Subscription Cancellation 
> Unit and start from 
> the beginning. 
> Please remember that this is the only way we will 
> accept for you to 
> unsubscribe from this service. 
> We have made every attempt to simplify the procedure 
> for your 
> convenience. Failure to comply with the unsubscribe 
> policy will result 
> in immediate termination of your subscription so 
> please follow the above 
> directions closely 
> 
> Regards 
> The Chevelle List 

Phil G. 65 SS

Reply via email to