> Phil, , is your hobby expensive ???? if yes thats really strange because we have the same one and mine is not..... just ask my girlfriend! hahahahahahaha nice words anyway
ciao Andr� > Hey guys: Great way to start my morning by laughing out loud!! > Soon as I saw "Remove me" "And let the games begin" I knew what was coming. I Love > it!!!!!!! This list is the greatest! Technical, enjoyable, entertaining, and at > times political & heart warming. Got to have a sense of humor to get through life. > Especially grown men with expensive grown-up toys. I don't play golf but I do spend > most spring to fall weekends with my car. Been 17 for almost 39 years now! Don't > ever quit guys. Leave the List! NEVER!!!!!!!!!!! > > Phil G. 65 SS > > > > > > > > > In a message dated 6/21/2004 8:04:20 PM Eastern Daylight Time, [EMAIL PROTECTED] > writes: > > > Perfect! > > > > Bill Lessenberry wrote: > > > > At 06:33 PM 6/21/2004, you wrote: > > > > let the games begin! > > > > Alan Moore <[EMAIL PROTECTED]> wrote: > > > > Remove me please!! > > > > Well OKden > > > > To unsubscribe from this service you must first > > purchase a > > Craft-O-Matic Adjustable Subscription Cancellation > > Unit. The unit can be > > obtained from most hardware stores and dental clinics. > > Be sure to obtain the proper permits to operate the > > unit from the > > Nuclear Regulatory Commission and the Food and Drug > > Administration in > > Washington D.C. USA. > > Be sure to carefully unpack the kit and place each > > component in its > > accompanying mesh safety bag. > > Mount the Pershing DF4 mesinator on top of the > > perforated Gerring Mach > > 77 refibulator and attach them using the > > eight-millimeter torque fork. > > Be sure that the refibulator is mounted at a 66 degree > > angle and > > properly dispersed so that it is flush with the curved > > section of the > > Pyrex thistle tube. > > Place the four sections of the triangular separation > > gear into the > > posture cylinder and lock them into place using the > > band aid adhesive strip. > > Insert the wiggling pin into the wobbling hole, making > > sure that it > > seated correctly. > > Place the D cell battery and the eleven 9 volt > > batteries in the power > > chamber. > > The device should be calibrated before operation using > > the optional > > digital corkscrew accessory pack prior to operation. > > Insert the digital corkscrew through the electronic > > combustion service > > chamber using caution not to touch the reinforced > > tungsten igniter > > control module and quickly turn the inverter drive to > > 28.6 degrees. > > Turn the Craft-O-Matic Adjustable Subscription > > Cancellation Unit upside > > down and hit the bottom plate with a 48-ounce > > ball-peen hammer while > > shaking the unit vigorously. > > Force open the door to the incineration valve > > compartment and set the > > pressure gauge to 719 psi. > > Close the door and seal it shut with duct tape. > > The unit should now be properly calibrated and ready > > to use. > > Before activating the Craft-O-Matic Adjustable > > Subscription > > Cancellation Unit, you must first elevate it to a > > height of 229 feet > > above sea level to insure that the unit receives the > > proper oxygen level > > and barometric pressure. > > Point the aerial to 17 degrees north by northeast to > > within the > > parameters of the Telstar GS-2 weather satellite and > > apply pressure to > > the wing shaft on the southern most section of the > > modular accelerator. > > Using the special ratchet adapter supplied with the > > unit, rotate the > > heater core to the "on" position. The "on" position > > has been obtained > > when the green light begins to flash, signifying that > > the red light is > > about to go off. > > Once the red light is off, flip the toggle switch > > labeled "ON/OFF" to > > the "ON" position and count to 47 before logging on to > > the system. > > Logon using your username and password and wait for > > the prompt. > > Once prompted you must check the box with the > > appropriate action you > > wish to take and then press the pressure release > > button and turn off the > > compressor while turning the hand crank at 231 meters > > per minute. > > Next, press control, alt, delete, caps lock, shift, > > number lock, escape > > and tab simultaneously. > > Press enter. You will have one second to complete the > > procedure. > > If you fail to respond in the time limit allowed, > > simply purchase a new > > Craft-O-Matic Adjustable Subscription Cancellation > > Unit and start from > > the beginning. > > Please remember that this is the only way we will > > accept for you to > > unsubscribe from this service. > > We have made every attempt to simplify the procedure > > for your > > convenience. Failure to comply with the unsubscribe > > policy will result > > in immediate termination of your subscription so > > please follow the above > > directions closely > > > > Regards > > The Chevelle List > > Phil G. 65 SS > >
