So the sockets fit right in to the back of the 69 dash?� How were they grounded?� Have any pics? J

 

I just spent some time trying different methods.� I took two metal brackets from hell and bent out the spades, then placed them in the sockets.� I took another two metal brackets from hell and spread some glue (albeit not the highest adhesive but pretty damn good) on the spades and then placed them in the sockets.� I let them sit for 10 minutes.� I came back, placed bulbs in all four sockets.� I came back in 5 minutes and found that every single one had at least some movement (1/4 of the way out).� One of the glued ones had came all the way out and one of the bent ones came � the way out (one spade completely out).

 

Anyone know of any aftermarket place that makes replacement sockets?� I do not want to be afraid every time I take off my dash bezel that I am going to lose a bulb and have to dismantle everything.� Even if the spades are glued, bent, nailed, stapled, welded, melded, etc…� I would still have the thought in the back of my head.

 

Thanks,

JB

 

 


From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of crobertson1
Sent: Tuesday, September 14, 2004 6:05 AM
To: [EMAIL PROTECTED]; 'The Chevelle Mailing List'
Subject: RE: [Chevelle-list] 69 Dash Lighting

 

JD

    I have the same problem with my 69. Some I used super glue on the spades.  The ones that were real bad, I found a wiring harness from a 75 corvette and spliced the sockets with a length of wire on my harness.

 

Craig

 

-----Original Message-----
From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Crazy Rusty
Sent: Monday, September 13, 2004 8:08 PM
To: 'The Chevelle Mailing List'
Subject: [Chevelle-list] 69 Dash Lighting

 

Does anyone out that have a sure-fire way to keep the bulbs and metal frame things from slipping out of the black sockets?  I just spent a few hours putting my dash in, taking it out (getting the bulbs came out), putting it back in, taking it back out (getting the bulbs that came out) , you get the picture.  I was thinking of using some contact cement on the little spade connectors that go down into the holder.  I think the bulbs fall out when that thing gets loose… Any ideas?

 

 

And if anyone know who the engineer was who designed those things, send him my way.

 

Thanks,

JB

Reply via email to