Hi everyone,,I'm finally putting our
'70 Chevelle SS for sale,if your interested, reply,and give me your e-mail,,I'll
send a pic. [EMAIL PROTECTED]
----- Original Message -----
Sent: Friday, December 03, 2004 8:49
PM
Subject: Re: [Chevelle-list]
request
thank you :-)
----- Original Message -----
Sent: Friday, December 03, 2004 9:44
PM
Subject: Re: [Chevelle-list]
request
To unsubscribe from this service you must first
purchase
a
Craft-O-Matic Adjustable Subscription Cancellation
Unit. The unit
can be
obtained from most hardware stores and dental clinics.
Be
sure to obtain the proper permits to operate the
unit from the
Nuclear Regulatory Commission and the Food and Drug
Administration
in
Washington D.C. USA.
Be sure to carefully unpack the kit and
place each
component in its
accompanying mesh safety bag.
Mount
the Pershing DF4 mesinator on top of the
perforated Gerring Mach
77
refibulator and attach them using the
eight-millimeter torque fork.
Be sure that the refibulator is mounted at a 66 degree
angle and
properly dispersed so that it is flush with the curved
section of
the
Pyrex thistle tube.
Place the four sections of the triangular
separation
gear into the
posture cylinder and lock them into place
using the
band aid adhesive strip.
Insert the wiggling pin into the
wobbling hole, making
sure that it
seated correctly.
Place the D
cell battery and the eleven 9 volt
batteries in the power
chamber.
The device should be calibrated before operation using
the optional
digital corkscrew accessory pack prior to operation.
Insert the
digital corkscrew through the electronic
combustion service
chamber
using caution not to touch the reinforced
tungsten igniter
control
module and quickly turn the inverter drive to
28.6 degrees.
Turn the
Craft-O-Matic Adjustable Subscription
Cancellation Unit upside
down
and hit the bottom plate with a 48-ounce
ball-peen hammer while
shaking the unit vigorously.
Force open the door to the incineration
valve
compartment and set the
pressure gauge to 719 psi.
Close
the door and seal it shut with duct tape.
The unit should now be
properly calibrated and ready
to use.
Before activating the
Craft-O-Matic Adjustable
Subscription
Cancellation Unit, you must
first elevate it to a
height of 229 feet
above sea level to insure
that the unit receives the
proper oxygen level
and barometric
pressure.
Point the aerial to 17 degrees north by northeast to
within the
parameters of the Telstar GS-2 weather satellite and
apply pressure to
the wing shaft on the southern most section of the
modular accelerator.
Using the special ratchet adapter supplied with
the
unit, rotate the
heater core to the "on" position. The "on"
position
has been obtained
when the green light begins to flash,
signifying that
the red light is
about to go off.
Once the red
light is off, flip the toggle switch
labeled "ON/OFF" to
the "ON"
position and count to 47 before logging on to
the system.
Logon
using your username and password and wait for
the prompt.
Once
prompted you must check the box with the
appropriate action you
wish
to take and then press the pressure release
button and turn off the
compressor while turning the hand crank at 231 meters
per minute.
Next, press control, alt, delete, caps lock, shift,
number lock,
escape
and tab simultaneously.
Press enter. You will have one second
to complete the
procedure.
If you fail to respond in the time limit
allowed,
simply purchase a new
Craft-O-Matic Adjustable Subscription
Cancellation
Unit and start from
the beginning.
Please remember
that this is the only way we will
accept for you to
unsubscribe from
this service.
We have made every attempt to simplify the procedure
for your
convenience. Failure to comply with the unsubscribe
policy will result
in immediate termination of your subscription so
please follow the above
directions closely
|
