Just to add a little info:
As Carl said, the fitting pictured is for the
trans. The fitting will probably go in the rear-passenger side of the
manifold.
The fitting for the brakes is MUCH bigger around. As Carl
said, it'll come off the back of the carb and will be about 1/2inch
in diameter
Pelle
-
Getting these wrong (and leaving them unplugged) might be contributing to
your poor idle issues.
Karl Groves
Master Certified CIW
http://www.karlgroves.com
Grayscale
Content Management System:
http://www.grayscalecms.com
Independent
Musician's Handbook:
http://www.indiebook.com
From: Carl Ziegler [mailto:[EMAIL PROTECTED]
Sent: Sunday, September 17, 2006 8:21 PM
To: The Chevelle Mailing List
Subject: Re: [Chevelle-list] Manifold vacuum fitting?The pictured item is for the vacuum to the trans. It typically has a hard steel line that goes into that fitting with a short piece of rubber hose to make the seal. The power brakes are off the back of the carb on bottom, at least that is the way my 72 is.
