Any help with Moser C-Clip Eliminators? I have sent two messages to Moser Engineering about this and haven't heard back yet - I'm pressed for time with this customer... Here is a copy of my message to Moser - has anyone here solved the same issue?
I have two issues with the installation of C-Clip Eliminator kit 9200 on a GM 12-bolt 8.875 axle that need to be resolved before I can continue. 1.) The instruction sheet mentioned adding threadlocker to the axle shaft where it will be pressed to the bearing. What threadlocker do you recommend? A Loctite 200 series threadlocker or 600 series for shaft bonding? 2.) The axle has no backing plates, there is a rear disc brake conversion that bolts to the opposite side of the housing flange. I was hoping you have come across this before and had spacers on hand. I included a drawing of what I sent to our fabricator - I hope my measurements are close. Can you either verify if my hole dimensions are correct or forward me a detailed machining drawing of the housing end? Thank you for your help, :D G r a n i t e C i t y P e r f o r m a n c e custom engineered competition components
gm8.875housingspacer.pdf
Description: Adobe PDF document
