I haven't really heard good or bad info but you might take a look at those made by DMH - http://www.dmhperformance.com/. These have slotted flanges that allow the installation to be rotated a bit for installation clearance.
Dale From: [email protected] [mailto:[email protected]] On Behalf Of bill Sent: Sunday, August 08, 2010 7:55 AM To: The Chevelle Mailing List Subject: Re: [Chevelle-list] Quick time Electric Cutouts ----- Original Message ----- From: Bob n Cheri <mailto:[email protected]> To: chevelle-list <mailto:[email protected]> Sent: Saturday, August 07, 2010 6:26 PM Subject: [Chevelle-list] Quick time Electric Cutouts Does or has anyone used the Quick Time Electric cutouts instead of the caps on on your exhaust systems? I'm thinking about a set but that's a lot of bucks if they don't last. Their 90 day warranty isn't too confidence inspiring either. I guess I want to know how well they fit. fit is good Do they leak at the butterflies. yes but just a bit Have you run into clearance problems ( will be going on a 71 SS 454 stock ride height with long tube headers and x pipe. you may need to move the floor depending on where they are located If you had issues with the company. How long did they last or are they still working. first set about 1 week the screws that hold the solinoid to the butterfly backed out and ripped out the wiring summit replaced them i took the new ones apart before i installed them and put locktight on all there screws Do any of you use the controller that can be purchased additionally. came with it I know 3 wing nuts and the caps come off but I was just looking at this as an option. Thanks, Bob Belz 71 SS 454
