I loaded the Adams7 software but it will nt see the MEMFTM400D.dat file. I copied the file from the sd card to the laptop....
I did read enough on https://chirp.danplanet.com/issues/1469 to figure out a way to use Chirp with the FTM400.... Basically someone uploaded a file (ftm400.py) and you load that into Chirp, then you open the file and you can use radioreference or whatever to load local repeaters, then save the file... Takes a little time to figure how to save it as the right file name,but not hard. I loaded all the local 2mtr/440 repeaters and pasted them into the .dat file,saved it and then loaded it into the radio through the sd card.... although I only added the TOP (vfo A) channels,it seems to be working just fine. Thank you for taking time to reply. /John N9UKX <http://www.avg.com/email-signature?utm_medium=email&utm_source=link&utm_campaign=sig-email&utm_content=webmail> Virus-free. www.avg.com <http://www.avg.com/email-signature?utm_medium=email&utm_source=link&utm_campaign=sig-email&utm_content=webmail> <#DAB4FAD8-2DD7-40BB-A1B8-4E2AA1F9FDF2> On Thu, Jun 13, 2019 at 4:44 PM Tom Henderson <[email protected]> wrote: > In my experience, just barely. > > Tom Henderson > > On 6/13/19 4:18 PM, Nigel A. Gunn G8IFF/W8IFF wrote: > > Does Yaesu's programming software not work? > _______________________________________________ > chirp_users mailing list > [email protected] > http://intrepid.danplanet.com/mailman/listinfo/chirp_users > This message was sent to fugawee at [email protected] > To unsubscribe, send an email to > [email protected] >
_______________________________________________ chirp_users mailing list [email protected] http://intrepid.danplanet.com/mailman/listinfo/chirp_users This message was sent to [email protected] at [email protected] To unsubscribe, send an email to [email protected]
