I have an RT Systems Yaesu programming cable for a Yaesu FT-1900 two-meter mobile radio that fits my new FTM-3200D radio. I installed the latest Chirp, as of today, and it knows about the FT-3200D. I plugged the cable into the computer USB and the radio microphone jack. By trial and error, I discovered that the FTM-3200D goes into CLONE mode by holding in SETUP and then turning it on. Also, by trial and error, I found that the FTM-3200D went into TRANSMIT mode to the computer by starting the Chirp Download from Radio, and then pressing REV on the FT-3200, whereupon the radio went to TX mode and began to count up, and Chirp also showed that it was downloading data. The process finished, the radio went back to CLONE, but Chirp returned a checksum error. Chirp does not display any radio data after the failure. To sum up, the radio is happy that it spoke to Chirp, but Chirp is not happy with what it heard, probably at the end of the exchange.
Does anyone know how I can get past this error message? Thank you and 73, Jan, KX2A _______________________________________________ chirp_users mailing list [email protected] http://intrepid.danplanet.com/mailman/listinfo/chirp_users This message was sent to [email protected] at [email protected] To unsubscribe, send an email to [email protected]
