Adding yourself to the "dialout" group should prevent you from having to do this.

Tom Henderson

On 12/7/19 6:58 PM, Pat Anderson wrote:
Oops, I should have said I am running Ubuntu Linux. Can't say anything if you are running something other than Linux.


On Sat, Dec 7, 2019 at 5:56 PM Pat Anderson <[email protected] <mailto:[email protected]>> wrote:

    Try this. Before you try to read from the radio, do "chmod 777
    /dev/ttyUSB0".  I have a Baofeng UV82HP and CHIRP reads and writes
    just fine once I have done this.

    Pat Anderson
    KD7OAC

    On Sat, Dec 7, 2019 at 5:48 PM Phil <[email protected]
    <mailto:[email protected]>> wrote:

        Thank you for reading this.

        I bought a Baofeng UV-82HP about four months ago and I cannot
        get Chirp
        to read from the radio, or in fact to do anything with the radio.

        I'm running Chirp under Kubuntu and have tried every Chip
        daily version
        over the past four months. This is the error message that I
        receive when
        I attempt to read from the radio:

        "Radio did not respond"

        These are the entered parameters:

        /dev/ttyUSB0
        Baofeng
        UV-82HP

        I have read and write access to the serial port which is the
        same port
        that I use for several application including programming an
        Arduino
        board. I have tried several different Baofeng models, just in
        case, with
        the same result.

        I've trimmed the plastic from the plug so that it slips into
        the radio's
        sockets more easily. I've attempted to read from the radio in
        both
        channel and frequency modes. Finally, I've searched the
        Internet for
        even the slightest clue but to no avail.

        I do not know anyone who owns a Baofeng radio or who uses
        Chirp. So this
        mailing list is my last hope.

        Any clues at all will greatly appreciated.

-- Regards,
        Phil

        _______________________________________________
        chirp_users mailing list
        [email protected]
        <mailto:[email protected]>
        http://intrepid.danplanet.com/mailman/listinfo/chirp_users
        This message was sent to Pat Anderson at
        [email protected] <mailto:[email protected]>
        To unsubscribe, send an email to
        [email protected]
        <mailto:[email protected]>


_______________________________________________
chirp_users mailing list
[email protected]
http://intrepid.danplanet.com/mailman/listinfo/chirp_users
This message was sent to Tom KM4UQB at [email protected]
To unsubscribe, send an email to [email protected]
_______________________________________________
chirp_users mailing list
[email protected]
http://intrepid.danplanet.com/mailman/listinfo/chirp_users
This message was sent to [email protected] at [email protected]
To unsubscribe, send an email to [email protected]

Reply via email to