Hello,
thanks for creating a cross platform program! But, I’m having a consistent
problem programming my iCom 2200H.
System:
2018 MacBookPro, OS 10.14.6
IOGear USB to Serial converter GUC232A, driver ATEN
ls /dev/cu*
4/26/20 results
/dev/cu.Bluetooth-Incoming-Port
/dev/cu.UC-232AC
/dev/cu.MacDonaldsiPhone-Wirele
Updated the IOGear converter driver from 1.6.0 to 1.6.2
kextstat:
com.aten.driver.PL2303 (1.6.0)
Fresh install of KK7DS Python
Updated to Chirp-unified-daily-20200430
Chirp:
Selecting UC232A for com port
downloading, then immediately uploading starts the clone then stalls at 1/3 of
progress bar.
Hitting cancel in the Clone Progress dialog generates the Beach Ball of Death
until force quit.
After force quit, Chirp won’t restart unless I reboot. The icon just bounces
in the dock.
installed the Prolific driver, with still same issue.
The 2200H is reading “CL IN”
Any suggestions to resolve this?
Thanks,
Glen MacDonald
KE7HIM
_______________________________________________
chirp_users mailing list
[email protected]
http://intrepid.danplanet.com/mailman/listinfo/chirp_users
This message was sent to [email protected] at [email protected]
To unsubscribe, send an email to [email protected]
