I should also add that I already went into the actual radio menu # 15 and changed the radio to 200 channel mode.
On Fri, May 1, 2020 at 3:09 PM AS <[email protected]> wrote: > Hi Nigel: > > Thanks for the reply. I don't see a settings tab. When I "download from > radio" and try and click on the "Properties" tab there is no response. I > hope that would be an area where I could increase the number of channels to > the specified 200 that is supposed to be available. It's like the radio is > stuck on alphanumeric mode. > > > > > On Fri, May 1, 2020 at 3:01 PM Nigel A. Gunn G8IFF/W8IFF <[email protected]> > wrote: > >> Is there a switch in the SETTINGS tab? >> >> On 01 May 2020 at 17:52 AS <[email protected]> wrote: >> >> Only 99 channels with Kenwood TM-281A >> >> Hi All: >> >> Been trying to use CHIRP to program my Kenwood TM-281A. This radio is >> specced for 200 channels but, according to literature, reverts to 100 >> channels when names are used. >> >> When I download from the radio it only allows me 100 channels (0-99), >> even when I import a CSV file with the names deleted. When I click on the >> memory range I am unable to go past 99 (upward arrow greyed out). >> >> Is there a way to open up the memory to 200 channels? >> >> Thanks! >> _______________________________________________ >> chirp_users mailing list >> [email protected] >> http://intrepid.danplanet.com/mailman/listinfo/chirp_users >> This message was sent to Nigel Gunn, W8IFF at [email protected] >> To unsubscribe, send an email to >> [email protected] >> >> >> >> >> Nigel A. Gunn, ///shoulders.outwards.resolutions tel +1 937 825 5032 >> Amateur Radio G8IFF W8IFF and GMRS WRBV701, e-mail [email protected] www >> http://www.ngunn.net >> >>
_______________________________________________ chirp_users mailing list [email protected] http://intrepid.danplanet.com/mailman/listinfo/chirp_users This message was sent to [email protected] at [email protected] To unsubscribe, send an email to [email protected]
