Hi, yes you are correct on the actual msg. No I have made double sure in selecting the correct radio i.e. UV 5 R. As I said, cannot understand why because I had downloaded from same radio previously.
Regards George On Wed, 24 Jun 2020, 14:14 Jim Unroe, <[email protected]> wrote: > On Wed, Jun 24, 2020 at 4:10 AM George Piek <[email protected]> wrote: > > > > Good day to you, I am using Chirp for programming my UV 5 R Baofeng > Radio. Suddenly when I request to "Download from Radio" I receive the > message " Not enough data" Why would that be please. I have used it before > and had no problems. > > > > Regards > > George > > Hi George, > > >From the information you have provided, I am going to guess that you > may be selecting the wrong model. Here's why. > > There is no CHIRP driver for any radio model that provides a " Not > enough data" message to the user. The word "enough" doesn't even show > up in any message for any radio driver module. So looking through all > of the Baofeng radio driver modules for messages that contain both > "not" and "data" I find "baofeng_common.py". It contains the following > message: "Error reading data from radio: not the amount of data we > want." Assuming this message is the actual message that you are > seeing, this allows me to get a list of all radio driver modules that > use "baofeng_common.py". They are as follows. > > baofeng_wp970i.py > gmrsuv1.py > mursv1.py > uv6r.py > uv5x3.py > > >From the above list only "baofeng_wp970i.py" and "uv6r.py" use the > Vendor: Baofeng selection. Assuming that "UV 5 R" means "UV-5R", if I > hook up a UV-5R and choose Vendor: Baofeng and Model: UV-6R, I get the > "Error reading data from radio: not the amount of data we want." > message (screen capture attached). > > Since the "UV-5R" and "UV-6R" selections are visually similar, I think > you may accidentally be choosing "UV-6R" instead of choosing "UV-5R". > > Jim KC9HI > _______________________________________________ > chirp_users mailing list > [email protected] > http://intrepid.danplanet.com/mailman/listinfo/chirp_users > This message was sent to George Piek at [email protected] > To unsubscribe, send an email to > [email protected]
_______________________________________________ chirp_users mailing list [email protected] http://intrepid.danplanet.com/mailman/listinfo/chirp_users This message was sent to [email protected] at [email protected] To unsubscribe, send an email to [email protected]
