Thank you very much quick response. It is very much appreciated I am using an FTDI chipsets table that I purchased from one of our fellow amateur colleagues.
I will try your suggestion in the morning and let you know how it goes. Assuming it goes well, you win the lottery joe > On September 7, 2020 2:52 PM Jardy via chirp_users > <[email protected]> wrote: > > > Use Device Manager to see what comm port you are connected to. Unplug and > plug back in your cable, the one you are using will disappear and come back. > Next, check the driver and cable model name. If it shows you are using a > Prolific cable, roll back your driver to 3.2.0.0. > > When you are going thru the clone process, always read the radio first, > modify your file, then write to the radio. When the instructions says to push > the Set button, it is the fastest push you can do and release, don’t press > too long. > > Jardy Dawson WA7JRD > > Message sent by....Oh look!! Pretty lights!! > > > > > > On Sep 7, 2020, at 14:41, D.J.J. Ring, Jr. <[email protected]> wrote: > > > > > > > > > > You have to select the USB port that your radio is > connected to. > > > > 73 > > > > DR > > > > On Mon, Sep 7, 2020 at 5:28 PM joe < [email protected] > > mailto:[email protected] > wrote: > > > > > > > Hi everyone, > > > > > > Windows 10 computer > > > > > > I am trying to clone the Yaesu FT8900R (this is the first > > > time) > > > > > > I use CHIRP and I follow the CHIRP instructions (same as in > > > Yaesu manual) > > > > > > I turn on the radio, go to F6 "clone start", then push "set" > > > > > > Nothing happens...after a few seconds, I get error message > > > stating it could not find the item location (com port). Tried several > > > times on all four active ports. > > > > > > Checked "device manager" and the four ports are active and > > > well > > > > > > Any help or suggestions will be greatly appreciated > > > > > > Joe > > > _______________________________________________ > > > chirp_users mailing list > > > [email protected] > > > mailto:[email protected] > > > http://intrepid.danplanet.com/mailman/listinfo/chirp_users > > > This message was sent to D.J.J. Ring, Jr. at [email protected] > > > mailto:[email protected] > > > To unsubscribe, send an email to > > > [email protected] > > > mailto:[email protected] > > > > > > > > _______________________________________________ > > chirp_users mailing list > > [email protected] > > http://intrepid.danplanet.com/mailman/listinfo/chirp_users > > This message was sent to Jardy at [email protected] > > To unsubscribe, send an email to > > [email protected] > > > > > _______________________________________________ > chirp_users mailing list > [email protected] > http://intrepid.danplanet.com/mailman/listinfo/chirp_users > This message was sent to joe Shapley at [email protected] > To unsubscribe, send an email to > [email protected] >
_______________________________________________ chirp_users mailing list [email protected] http://intrepid.danplanet.com/mailman/listinfo/chirp_users This message was sent to [email protected] at [email protected] To unsubscribe, send an email to [email protected]
