Thanks , I’ll try it. Jerry NV7GS +++++ Give a person a fish and you feed them for a day. Teach a person to use the Internet and they won't bother you for weeks, months, maybe years.
~Unknown > On Jun 7, 2021, at 01:28, Mark Dixon <[email protected]> wrote: > > Hi Jerry. > > A common cause for that problem is the cable having insufficient or > intermittent contact with the socket on the side of the radio. The > plastic around the socket on some radios and/or the plastic around the > connector pins on the cable is sometimes a bit to thick or irregular > making for a poor connection - try squeezing the cable tightly into the > side of the radio and maybe even holding it in while attempting the > upload again (being careful not to squeeze PTT at the same time). > > Cheers, Mark Dixon > > >> On 7/06/2021 11:01 am, Gerald Stein wrote: >> I’m new to Chirp software. The equipment I’m using is a Yaesu FT 60 and a >> windows 10 laptop. I acquired the cable sometime ago, but haven’t used it >> until recently. The build I am using is the most recent available. Here’s >> the problem: I connected the radio to the laptop and uploaded the radio’s >> contents without problem. I made some changes to the repeaters listed, saved >> the changes, and then tried to download them back to the radio. The >> download started normally, but quickly the following error message appeared: >> “failed to communicate with radio: radio did not respond.” Any suggestions? >> >> Thanks and advance for your efforts. >> >> Jerry >> NV7GS >> +++++ >> Give a person a fish and you feed them for a day. Teach a person to use the >> Internet and they won't bother you for weeks, months, maybe years. >> >> ~Unknown >> _______________________________________________ >> chirp_users mailing list >> [email protected] >> http://intrepid.danplanet.com/mailman/listinfo/chirp_users >> This message was sent to Mark Dixon at [email protected] >> To unsubscribe, send an email to >> [email protected] > _______________________________________________ > chirp_users mailing list > [email protected] > http://intrepid.danplanet.com/mailman/listinfo/chirp_users > This message was sent to Jerry Stein at [email protected] > To unsubscribe, send an email to > [email protected] _______________________________________________ chirp_users mailing list [email protected] http://intrepid.danplanet.com/mailman/listinfo/chirp_users This message was sent to [email protected] at [email protected] To unsubscribe, send an email to [email protected]
