Radio should be ON when up or downloading. Remove the driver and cable program, reboot PC reload driver SHOULD correct issue. If using aftermarket cable check to see contacts are CLEAN (*shiny) and fit TIGHTLY into the mike provisioning adapter (Mic jack) DO NOT touch ANY buttons while programming. Worst case, prior to programming RESET the radio to factory resets then load your amended program.
On Thu, Aug 19, 2021 at 2:03 PM Jim Unroe <[email protected]> wrote: > Hi Eric, > > On Thu, Aug 19, 2021 at 12:47 PM Eric Chopin <[email protected]> wrote: > > > > UV5XP.... > > However to get CHIRP to see the radio either in the 'Download from > radio' > > or 'Upload to radio' ... with the cable plugged in to my PC or my > MAC, the > > radio must me switched OFF...then as I select 'Download or upload' > as I > > select 'OK' i must immediately switch ON my radio then CHIRP sees it > and > > proceeds. If I try to 'Download or upload' with the radio already > switched > > on I get the message 'The radio did not respond' as CHIRP cannot see > it > > connected. > > Any suggestions? > > Thanks > > VE7ECJ > > That sounds like a programming cable/driver issue. Also, to program > that radio you must choose... > > Vendor: Radioddity > Model: UV-5G > > Jim KC9HI > _______________________________________________ > chirp_users mailing list > [email protected] > http://intrepid.danplanet.com/mailman/listinfo/chirp_users > This message was sent to [email protected] at > [email protected] > To unsubscribe, send an email to > [email protected] >
_______________________________________________ chirp_users mailing list [email protected] http://intrepid.danplanet.com/mailman/listinfo/chirp_users This message was sent to [email protected] at [email protected] To unsubscribe, send an email to [email protected]
