I just scanned the UV-5R manual and could find no mention of such a 'feature' or 'setting', I suspect this is something enabled in the CHIRP software interface that is not supported by the Baofeng radio itself.
The closest function setting I could find were the "MDF-A" and "MDF-B" that determine what is displayed (freq, ch, or name) for the A and B sides of the receiver. Ken, N2VIP > On May 16, 2022, at 07:43, [email protected] wrote: > > Hi Folks. > > Have just set up my UV-5RE Plus with relevant channels and settings but > one that is causing me a bit of a head scratcher in the Work Mode > Settings is the MR A Channel and MR B Channel. > > Maybe I'm misunderstanding this but I set these two fields up to hold > location 16 and location 60 as 'Defaults' so that no matter what channel > I left it at when I switched the radio off, when I switched it back on > again, it would revert back to the 'Defaults' > > If I have understood this facility correctly, it isn't doing it. If I > move off a default channel using the up or down arrow then switch the > radio off then back on again, it stays at the last positions - it > doesn't revert back to the defaults. > > Have I misintrepreted this?? > > Regards > > Declan > _______________________________________________ > chirp_users mailing list > [email protected] > http://intrepid.danplanet.com/mailman/listinfo/chirp_users > This message was sent to Ken Hansen at [email protected] > To unsubscribe, send an email to > [email protected] > To report this email as off-topic, please email > [email protected] _______________________________________________ chirp_users mailing list [email protected] http://intrepid.danplanet.com/mailman/listinfo/chirp_users This message was sent to [email protected] at [email protected] To unsubscribe, send an email to [email protected] To report this email as off-topic, please email [email protected]
