Hi Greg, On Mon, Jun 6, 2022 at 2:23 PM Gregory Beyer <[email protected]> wrote: > > Hi, I'm a new amateur so sorry if this seems a dumb question. > > For repeaters with only an uplink tone, one simply selects "Tone" in Tone > mode and selects the single tone to get into the repeater. > > Some repeaters list both an uplink and a downlink tone. In this case, which > Tone mode option do I select? And in which property do I enter the downlink > tone?
A downlink tone is never required. So you are always good to only configure an uplink tone as you described above. But in the case where you want to also have a downlink tone and the uplink/downlink tones are the same you set Tone Mode = TSQL and set the ToneSql field to the desired single tone (the Tone field is not used). Where the uplink and downlink tones are different use Tone Mode = Cross and configure Cross Mode as described by the guide mentioned in another reply. > > Thank you. > > -- > ________________________ > > Greg Beyer > [email protected] Jim KC9HI _______________________________________________ chirp_users mailing list [email protected] http://intrepid.danplanet.com/mailman/listinfo/chirp_users This message was sent to [email protected] at [email protected] To unsubscribe, send an email to [email protected] To report this email as off-topic, please email [email protected]
