| Marty,
As it says at the bottom of the email:
To unsubscribe, send an email to [email protected]
Ken, N2VIP Would someone please unsubscribe me or remove me from their email lists from these notifications...
This message was sent to Marty McInerney at [email protected]Best, Marty ------- Original Message -------
On Friday, January 6th, 2023 at 09:55, K0LNY_Glenn < [email protected]> wrote:
Another approach is to bevel the four edges with a
pocket knife, affectively making the insertion piece a bit smaller, because it
may not be the flat surface that is the problem, but the outer diameter of the
plug
That is what I wound up doing (I used a Dremel and a rattail file) and it solved the problem nicely.
The Doctor [412/724/301/703/415/510]
The old world is dying, and the new world struggles to be born. Now is the time of monsters.
chirp_users mailing list
[email protected]
http://intrepid.danplanet.com/mailman/listinfo/chirp_users
This message was sent to Marty McInerney at [email protected]
To unsubscribe, send an email to [email protected]
To report this email as off-topic, please email [email protected]
Searchable archive: https://www.mail-archive.com/[email protected]
-- Marty McInerney
Charlotte, NC 704-534-6726
|
_______________________________________________
chirp_users mailing list
[email protected]
http://intrepid.danplanet.com/mailman/listinfo/chirp_users
This message was sent to [email protected] at [email protected]
To unsubscribe, send an email to [email protected]
To report this email as off-topic, please email
[email protected]
Searchable archive:
https://www.mail-archive.com/[email protected]
