Try just turning it on without going into clone mode. Then tell chirp to connect. If the radio is supported by chirp and your drivers are correct it should connect.
Your first action after connecting is to download an image from the radio. Dave W2IJL On Fri, Mar 3, 2023, 14:08 Jim Overstreet <[email protected]> wrote: > I have tried everything in the instructions and cannot get > > Chirp to communicate with the radio. As per the instructions, you > > turn the radio off, connect the USB cable, then turn on the radio while > > holding down the F/W key which puts the radio in CLONE mode which > > shows on the display. Then, you hit the band key and it tries to > communicate > > with the radio. At first, it looks like it will work but after about 20 > seconds > > ERROR appears in the display. I followed the instructions just as shown > > when you start the process, but always get the ERROR message. Just > > wondering if anyone has had success with the VX-3? WHat am I doing wrong? > > Thanks, > > Jim, WA5DXP > > > _______________________________________________ > chirp_users mailing list > [email protected] > http://intrepid.danplanet.com/mailman/listinfo/chirp_users > This message was sent to W2IJL at [email protected] > To unsubscribe, send an email to > [email protected] > To report this email as off-topic, please email > [email protected] > Searchable archive: > https://www.mail-archive.com/[email protected]
_______________________________________________ chirp_users mailing list [email protected] http://intrepid.danplanet.com/mailman/listinfo/chirp_users This message was sent to [email protected] at [email protected] To unsubscribe, send an email to [email protected] To report this email as off-topic, please email [email protected] Searchable archive: https://www.mail-archive.com/[email protected]
