It works now... out of the box...
Thanks!

Now I have to learn how to work with a camera, with capturing the
video and editing.
Any advises and howto's are welcome!

\d

2009/9/22, Norval Watson <[email protected]>:
> Firewire handling changed after about 2.6.25 kernels. If you have a newer
> kernel with experimental firwewire stack you will have to do some googling.
> With my self-compiled 2.6.29 kernel I set up menu config as follows
>
>     Device Drivers --->
>         IEEE 1394 (FireWire) support --->
>             < > New FireWire stack, EXPERIMENTAL
>             <M> Stable FireWire stack
>             <M>   OHCI-1394 controllers
>             <M>   PCILynx controller
>             <M>   Storage devices (SBP-2 protocol)
>             [ ]     Enable replacement for physical DMA in SBP2
>             <M>   IP over 1394
>             <M>   raw1394 userspace interface
>             <M>   video1394 userspace interface
>             <M>   dv1394 userspace interface (deprecated)
>             [ ]   Excessive debugging output
>
> In other words. experimental stack is disabled.
> But maybe it works now, someone else may have better information.
> HTH
> Norv
>
>  *******************************************
> My art, blog, films, music, photos, tweets -
> http://www.norvalwatson.com
>
>
>
> ----- Original Message ----
>> From: Schoap D <[email protected]>
>> To: [email protected]
>> Sent: Tuesday, 22 September, 2009 12:11:25 AM
>> Subject: Re: [CinCV] cheapo video camera
>>
>> 2009/9/20, Norval Watson :
>> >
>> >
>> >
>> >
>> >>
>> >> I bought an Samsung VP-D391, but I have no idea how to connect it to
>> >> the computer....?
>> >>
>> >>
>> > If it is like the 371, you need a Firewire input on your computer. Then
>> > you
>> > need to buy a Firewire cable.
>> > Connect the camera to the computer with the Firewire cable and capture
>> > the
>> > video with Kino (GUI) or dvgrab (command-line).
>> > If the computer grumbles you might have to load a module which I think
>> > is
>> > raw1394.
>>
>> Should the camera pop up in 'devices recently plugged in' in KDE4?
>> How do I load the module?
>>
>> I tried:
>>
>> # modprobe raw1394
>> FATAL: Module raw1394 not found.
>>
>> _______________________________________________
>> Cinelerra mailing list
>> [email protected]
>> https://init.linpro.no/mailman/skolelinux.no/listinfo/cinelerra
>
>
>
>
> __________________________________________________________________________________
> Get more done like never before with Yahoo!7 Mail.
> Learn more: http://au.overview.mail.yahoo.com/
>
> _______________________________________________
> Cinelerra mailing list
> [email protected]
> https://init.linpro.no/mailman/skolelinux.no/listinfo/cinelerra
>

_______________________________________________
Cinelerra mailing list
[email protected]
https://init.linpro.no/mailman/skolelinux.no/listinfo/cinelerra

Reply via email to