Ok The 2950G Switch is L2, and I have the same default-gateway on both.
Thanks Michael K. Smith - Adhost escribió: > Hello Juan: > > >> -----Original Message----- >> From: [EMAIL PROTECTED] [mailto:cisco-nsp- >> [EMAIL PROTECTED] On Behalf Of Juan C. Crespo R. >> Sent: Thursday, March 29, 2007 6:51 AM >> To: [email protected] >> Subject: Re: [c-nsp] Catalyst 2950G Trunking Issue >> >> Reposting.... >> >> SWITCH-A#show interfaces gigabitEthernet 0/1 trunk >> >> Port Mode Encapsulation Status Native vlan >> Gi0/1 on 802.1q trunking 1 >> >> Port Vlans allowed on trunk >> Gi0/1 1,10-25,354,456,845 >> >> Port Vlans allowed and active in management domain >> Gi0/1 1 >> >> Port Vlans in spanning tree forwarding state and not pruned >> Gi0/1 1 >> >> >> SWITCH-A#show interfaces vlan 1 >> Vlan1 is up, line protocol is up >> Hardware is CPU Interface, address is 03b0.24b1.5180 (bia >> 03b0.24b1.5180) >> Internet address is 10.0.0.1/24 >> MTU 1500 bytes, BW 1000000 Kbit, DLY 10 usec, >> reliability 255/255, txload 1/255, rxload 1/255 >> Encapsulation ARPA, loopback not set >> ARP type: ARPA, ARP Timeout 04:00:00 >> Last input never, output never, output hang never >> Last clearing of "show interface" counters never >> Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: >> > 0 > >> Queueing strategy: fifo >> Output queue: 0/40 (size/max) >> 5 minute input rate 0 bits/sec, 0 packets/sec >> 5 minute output rate 0 bits/sec, 0 packets/sec >> 25 packets input, 3264 bytes, 0 no buffer >> Received 0 broadcasts (0 IP multicast) >> 0 runts, 0 giants, 0 throttles >> 0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored >> 164 packets output, 0 bytes, 0 underruns >> 0 output errors, 4 interface resets >> 0 output buffer failures, 0 output buffers swapped out >> >> SWITCH-A# show arp >> Protocol Address Age (min) Hardware Addr Type Interface >> Internet 10.0.0.1 - 03b0.24b1.5180 ARPA Vlan1 >> >> >> SWITCH-B#show interfaces gigabitEthernet 0/1 trunk >> >> Port Mode Encapsulation Status Native vlan >> Gi0/1 on 802.1q trunking 1 >> >> Port Vlans allowed on trunk >> Gi0/1 1,10-25,354,456,845 >> >> Port Vlans allowed and active in management domain >> Gi0/1 1 >> >> Port Vlans in spanning tree forwarding state and not pruned >> Gi0/1 1 >> >> >> SWITCH-B#show interfaces vlan 1 >> Vlan1 is up, line protocol is up >> Hardware is CPU Interface, address is 03b2.24b1.5180 (bia >> 03b2.24b1.5180) >> Internet address is 10.0.0.2/24 >> MTU 1500 bytes, BW 1000000 Kbit, DLY 10 usec, >> reliability 255/255, txload 1/255, rxload 1/255 >> Encapsulation ARPA, loopback not set >> ARP type: ARPA, ARP Timeout 04:00:00 >> Last input never, output never, output hang never >> Last clearing of "show interface" counters never >> Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: >> > 0 > >> Queueing strategy: fifo >> Output queue: 0/40 (size/max) >> 5 minute input rate 0 bits/sec, 0 packets/sec >> 5 minute output rate 0 bits/sec, 0 packets/sec >> 210 packets input, 15072 bytes, 0 no buffer >> Received 0 broadcasts (0 IP multicast) >> 0 runts, 0 giants, 0 throttles >> 0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored >> 34 packets output, 0 bytes, 0 underruns >> 0 output errors, 4 interface resets >> 0 output buffer failures, 0 output buffers swapped out >> >> SWITCH-B# show arp >> Protocol Address Age (min) Hardware Addr Type Interface >> Internet 10.0.0.2 - 03b2.24b1.5180 ARPA Vlan1 >> >> >> >> SWITCH-B#ping 10.0.0.1 >> >> Type escape sequence to abort. >> Sending 5, 100-byte ICMP Echos to 10.0.0.1, timeout is 2 seconds: >> ..... >> Success rate is 0 percent (0/5) >> >> >> >> SWITCH-A#ping 10.0.0.2 >> >> Type escape sequence to abort. >> Sending 5, 100-byte ICMP Echos to 10.0.0.2, timeout is 2 seconds: >> ..... >> Success rate is 0 percent (0/5) >> SWITCH-A# >> >> > > > Depending on whether or not your switch is running in L2 or L3 mode, do > you have either a default route, default-gateway or both? For testing, > you may want to set the appropriate variable to the other device. > > Mike > > > > _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
