Thanks bep and everyone for the feedback... I'm up for the challenge ;)

We're going to install a 3640 there in the next couple of weeks that won't
be put into production right away - then I can work on actual config which
will probably make this easier..

All the best,

Paul
 

-----Original Message-----
From: Bruce Pinsky [mailto:[EMAIL PROTECTED] 
Sent: Wednesday, April 04, 2007 1:28 PM
To: Paul Stewart
Cc: [EMAIL PROTECTED]; [email protected]
Subject: Re: [c-nsp] Policy Based Routing Question

-----BEGIN PGP SIGNED MESSAGE-----
Hash: SHA1

Paul Stewart wrote:
> Thanks.. yes, I believe this would work but kind of messy ;)  I'm 
> trying to find a way to set costs based on source/destination of IP 
> addresses I guess you could say.... never done route-maps in OSPF - is 
> it basically same as BGP route-maps work?
> 

Sounds like you can classify the traffic by sources and destinations.  You
may be able to put them in VRFs, use OSPF in each VRF, and then use floating
statics pointing across VRFs for backup.

A little more detail about topology and service location might help lead to
other suggestions as well.

- --
=========
bep

-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.4.4 (MingW32)
Comment: Using GnuPG with Mozilla - http://enigmail.mozdev.org

iD8DBQFGE+ANE1XcgMgrtyYRAmr8AJ9BgK3xJKpUs2lPgBLrfxUlsC3kZgCgjrZT
sbUbTSfZTV8UTUmErd7JI+A=
=zbKl
-----END PGP SIGNATURE-----

_______________________________________________
cisco-nsp mailing list  [email protected]
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/

Reply via email to