This is not something to worry about much, given the fact this msg happend on a shutdown port.
We keep monitoring various broadcast suppression (ie storm control) bits in the ASIC and if there is a mismatch between what is software configuration and the hardware, we correct it and also print a syslog message. In your case, there was some of these registers bits that were not consistent with software configuration (probably some bug between software and hardware state for shutdown ports). I don't know why we even print syslog message for this as it is not needed. There is no user notification needed, as it is an internal firmware register monitoring mechanism. sukumar On Wed, 18 Apr 2007, Matti Saarinen wrote: > > Last night one 6509/sup2 running 12.2(18)SXF6 logged the following > message: > > %PM_SCP-SP-2-LCP_FW_ERR_INFORM: Module 6 is experiencing the following error: > Port 5 BCast Suppress Value Changed: exp: 0x0 actual:0x3 > > I couldn't find any information what the message means. Has anyone else > seen similar? > > Module 6 is WS-X6408A-GBIC and the configuration of the interface Gi6/5 > looks like this: > > rtr#sh run int gi6/5 > Building configuration... > > Current configuration : 76 bytes > ! > interface GigabitEthernet6/5 > no ip address > shutdown > no cdp enable > end > > > Cheers, > > -- > - Matti - > _______________________________________________ > cisco-nsp mailing list [email protected] > https://puck.nether.net/mailman/listinfo/cisco-nsp > archive at http://puck.nether.net/pipermail/cisco-nsp/ > _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
