Azher Amin ha scritto: > Hi, > > I have a 2Mb serial link with the main provider. However when i issue > the following command, it says 'Available Bandwidth 1536 kilobits/sec'. > Can some one plz explain why it is this behavior? > By default CBWFQ use 75% of interface bandwidth. You can tune this behaviour with max-reserved-bandwidth 100 command on interface. >From Cisco site: "However, the total amount of bandwidth allocated for all classes included in a policy map must not exceed 75 percent of the available bandwidth on the interface. The other 25 percent is used for control and routing traffic. (To override the 75 percent limitation, use the max-reserved bandwidth command.) If not all of the bandwidth is allocated, the remaining bandwidth is proportionally allocated among the classes, based on their configured bandwidth."
Regards, Gianluca _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
